Harley-Davidson DETACHABLE SISSY BAR SIDE STRAPS INSTALLATION INSTRUCTIONS

0

Filed Under (Harley Davidson) by admin on 20-04-2012

download
1. Remove factory sissy bar upright. Save upright if to be reused. Remove the two factory buttonhead screws and washers from the fender support on each side. Remove factory side plates. Discard side plates and factory hardware. 2. Cement the Plastic Sliders (item #1) into the brackets on the Khrome Werks Side Straps (item #2), using contact glue. 3. Install the special buttonhead screws through the flanged spacers (items #7, 8), then through the fender supports, frame, and into the fender. 4. Assemble the Knurled Knob (item #6) to the Side Strap, using the 1⁄ 4 “-20 x 1⁄ 2 ” screw, chrome washer and compression spring (items #3, 4, 5). The spring goes under the washer and into the counterbore of the knurled knob. 5. Install your sissy bar upright into the Side Straps, using the 1 ⁄ 4 “-28 x 3⁄ 4 ” screws provided (item #9).

HARLEY DAVIDSON XL SOLO CUSTOM SEAT KITS INSTALLATION MANUAL

0

Filed Under (Harley Davidson) by admin on 02-03-2011

download
INSTALLATION 1. Refer to the Owner’s Manual and follow the instructions given to remove the seat. 1 2 4 1 3 is03341 1. Stock retention nut and washer 2. Plastic cap 3. Rearward fender hole 4. Center fender hole Figure 1. Retention Nut and Plastic Cap Location 2. For models that had a solo seat: Proceed to Step 3. For models that had a 2-up seat: The retention nut and washer must be moved from the rearward mounting hole to the center fender hole where the rear seat bracket will be attached. Use a cable strap to aid in this step as fol- lows: a. See Figure 1. Remove retention nut from rearward fender hole (3) and plastic cap (2) from center fender hole (4). b. Install plastic cap into the rearward fender hole. c. See Figure 2. Place the retention nut over the cable strap so the wide end of the nut rests on the eye of the cable strap. Thread the cable strap up under the fender and through the center fender hole. Pull up on the cable strap to hold the nut snug against the underside of the fender. d. With the rib of the retention nut seated into the notch in the fender hole, slide the retention washer into place from the rear. This will lock the retention nut in place. 3. Position the solo seat on the motorcycle frame with the mounting bracket at the rear. Bring the seat forward and engage the tab on the seat into the slot at the base of the fuel tank. 4. See Figure 3. Secure the seat to the fender using the knurled knob (3) and neoprene washer (4) from the kit. Install the washer on the knob and tighten the knob securely to the fender seat nut