Kawasaki Vulcan 500 Receiver Hitch Installation Manual

0

Filed Under (Kawasaki) by admin on 06-05-2012

download
1) Place motorcycle on its side stand on a firm level surface. 2) Remove saddlebags if any. 3) Remove rear riders pegs. 4) Attach front of bracket A (left side) and bracket B (right side) between rear footpeg motorcycle bracket and rear footpeg. Use new bolt provided (Bolt assortment included to accommodate some accessories) 5) Attach bracket E (left side) and bracket F (right side) to two rear fender attachment bolts. Use new bolts provided. (Bolt assortment included to accommodate some accessories) 6) Attach bracket C (left side) and bracket D (right side) to brackets E and F and to second holes on rear of hitch. 7) Attach rear of brackets A and B to BOTTOM of hitch arms 8) Tighten all bolts. Receiver hitch diagram Leveling stand screw jack installation After hitch is installed, install leveling stand screw jacks to hold motorcycle in an upright and level position in order to install or remove InstaTrike. 1) Thread right side screw jack into leveling stand bracket on bracket B and adjust leveling jack bolt out until motorcycle will be level against it. 2) Push motorcycle over from left side until right screw jack is touching floor.

Honda Shadow750 ACE Installation Manual

0

Filed Under (Honda) by admin on 21-11-2010

download
1) Place motorcycle on a smooth level surface on its side stand. 2) Install leveling screw jacks so that motorcycle is in an upright and level position. 3) Remove saddlebags. 4) Mount bracket A ( left side ) to the 3 bolts that attach the rear fender and sub frame to the main motorcycle frame. new bolts provided 5) Mount bracket B ( right side ) to the 3 bolts that attach the rear fender and sub frame to the main motorcycle frame. new bolts provided 6) Bracket C mounts to the outside of bracket A at the rear lower hole. ( left ) 7) Bracket D mounts to the outside of bracket B at the rear lower hole. ( right ) 8) Bracket E ( left ) attaches to the outside of the motorcycle frame just under the rear foot peg and above the frame weld with the provided U-bolt. see diagram 9) Bracket F ( right ) attaches to the outside of the motorcycle frame just under the rear foot peg and above the frame weld with the provided U-bolt. see diagram 10) Bolt brackets C and D to the top rear of the receiver hitch. 11) Bolt brackets E and F to the top of the forward arms of the receiver hitch. 12) Tighten all bolts at this time. 13) Remount saddlebags and check all bolts for tightness. 1. Place your motorcycle on a smooth level surface and attach leveling jack stands. 2. Assemble axles, wheels, and fenders onto the tow-pac hitch cart. 3. Push the hitch mount into the receiver hitch. (this might bea little difficult until you get use to doing it. Removing the paint from the hitch mount and applying a little grease will help.) 4. Place the hitch pin through the receiver hitch and hitch mount ( alignment plate ). Install and tighten the tension bolt. 5. Align InstaTrike wheels. (initial installation only. Check periodically and realign if necessary) 6. Bolt lean stop braces to hitch. (Bolt inserts from the bottom) Be certain to replace washers/spacers in the same configuration as when you removed them.