SR-i500 FM 2-Way Security System INSTALLATION MANUAL AND USER'S GUIDE

0

Filed Under (Yamaha) by admin on 15-01-2012

download
Perimeter sensor – A miniature multi stage microwave sensor that detects motion in mass around the motorcycle, and uniquely protects its parts and accessories. Detects any attempt to tamper with saddlebags, luggage or accessories. • Ignition disable and anti-hijack kit – Allows remote disabling of the motorcycle’s electrical system, should someone force you off your bike. Also prevents the engine from being started when the system is armed. • Back-up battery Transmitter -Built in back up power capacitors with voltage sensing circuitry will ensure operation of the paging system even if wires are cut or battery is disconnected. • Factory Connector Kits -OEM style connectors that simply plug into the motorcycle’s factory wiring harness. Connector kits are available for select motorcycle models.

HARLEY DAVIDSON FL BACKREST PAD KITS INSTALLATION MANUAL

0

Filed Under (Harley Davidson) by admin on 23-02-2011

download
INSTALLATION 1. See Figure 1. If necessary, cut the plastic rain seal away from the three pre-cut screw holes (D) in the backrest pad (1) to prevent the plastic from catching in the threads. 2. On motorcycles with Detachable Sissy Bar Upright installed: a. Install three long spacers (3) into the pre-cut holes in the backrest pad. b. Position the backrest pad against the sissy bar upright (A). On motorcycles with Detachable Short Passenger Sissy Bar Upright installed: a. Install three long spacers (3) into the pre-cut holes in the backrest pad. b. Position the backrest pad against the detachable short passenger sissy bar upright (B), inserting the three spacers through the slots in the sissy bar tabs (C). On motorcycles with Luggage installed: a. Install three short spacers (4) into the pre-cut holes in the backrest pad. b. Position the backrest pad against the upright (A). 3. Place the mounting bracket (2) against the spacers, so that the holes of the mounting bracket align with the spacers. NOTE To avoid misalignment and cross threading of the screws, start all three screws into the backrest before tightening. 4. Insert a screw (5) from the kit through one of the spacers, and carefully thread it 4-5 turns into the mating hole in the backrest pad. Repeat with the other two screws. DO NOT tighten a screw until all three screws have been started. NOTE Spacers must seat squarely against the mounting bracket. 5. Once all three screws have been carefully started into the three holes of the backrest pad, tighten the screws to 7-10 in-lbs (0.8-1.1 Nm)

Incoming search terms: