SUZUKI GSX-R600 X-TRE Power Box Installation and Operation Manual

0

Filed Under (Suzuki) by admin on 10-02-2012

download
Installation Disclaimer: Do not attempt to install the product if you don’t have basic mechanical skills. HealTech Electronics Ltd. and its distributors shall not be liable for any loss or damage caused by improper installation. 1. Check the supplied parts: – X-TRE Power Box – Wiring harness – Yellow butt connectors, gel-filled (2 pcs) – Red tap connector, gel-filled – 4p jumper-plug – Cable ties (2+1 pcs) – Velcro strips – HealTech stickers (2+2 pcs) – Manual 2. Make sure the ignition key is in OFF position. Remove the seat. 3. Locate the ECM (Engine Control Module) under the seat. 4. Release the fuse box and relay switch to clean the area around the ECM connectors. 5. Locate the Black wire with thin dark Green stripe (B/G) , in the ECM connector. The wire position for different models is as follows: GSX-R600 K8-K9 GSX-R750 K8-K9 GSX-R1000 K7-K9 Black connector, pin no. 23 Middle row, 2nd wire from left to right at the back (wire) side of the connector ALL other years and models Black connector, pin no. 6 Top row, 6th wire from right to left at the back (wire) side of the connector

Honda CBR 954 RR Undertail Kit INSTALLATION

0

Filed Under (Honda) by admin on 04-12-2011

download
Carefully remove the tail section body work. Save all bolts, washers and plastic rivets for re-installation of tail. Disconnect and remove the brake light (with all mounting grommets and washers), license plate and turn signals, key lock (with clip) and move all wiring out of the cutting areas. Remove the two bolts at the rear end of the stock fender (inside glove box) to allow the end to hang down for cutting.
2) Using a “Dremel” tool or cutting disc (this can also be done using a sharp edged knife, but is not recommended), remove the plastic shown in the photos to the above and below. Be sure to take your time cutting, so that you don’t cut away any more plastic than necessary. Honda CBR954RR Undertail Kit (2002-03, Available in: Honda Red, Gloss Black and Gun Metal) 3) *Install license plate brackets to back side of license plate as shown. Now hold license plate in desired location on undertail, carefully mark and drill holes, install using the two (2) sets of allen bolts and lock nuts. 4) Insert undertail left side first, then right side, be carefully not to crack
or scratch undertail. Use your stock plastic screw rivets to hold under- tail in place. Tighten all hardware on tail section, attach seat.
5) Using clips, splice your turn signal wires to the signals in the undertail. On the bike; the orange wire is the the left turn, light blue wire is the right turn and the green wires are the grounds. On the undertail the red wires are the power wires and the black wires are the ground. * After this modification your undertail is not returnable. Paint is not warrantied against paint chips, flaking or scratches from installation or rocks being thrown from tire into the tray. Need Help? If you need additional help with the installation of the undertail, go to www.hotbodiesracing.com and look for the “FAQs” link at the bottom of the home page. Most of your general questions can be answered on those pages. This installation does require a basic mechani- cal aptitude, if in doubt, contact your local motorcycle shop and have a professional mechanic perform the installation, 3 hours is the average installation time

Incoming search terms: