DUCATI MONSTER OGGY KNOBB KIT installation Instructions

0

Filed Under (Ducati) by admin on 26-10-2010

download
Congratulations on purchasing your Oggy Knobb kit. It has been designed to reduce damage to your motorcycle from impact and abrasion by the road surface in an accident. We have used only the highest quality materials to achieve the strength and appearance your investment deserves. Carefully read the fitting instructions below and check you kit contents before starting installation. If you are unsure or not confident about installing Oggy Knobbs yourself, see your mechanic. Note-Does not fit pre August 1998 600 & 750 or Montsers using 12mm engine mounting bolt. Instructions: 1. Remove the blanking plugs and engine mounting bolt which passes through the frame and crankcases. The position of this bolt can be seen from the photo above. 2. Fit the supplied threaded rod in place of the original bolt with an even amount projecting from each side. 3. Fit the aluminium spacer on each side making sure the smaller diameter seats inside the recess in the frame. 4. Fit the Oggy Knobb, flat washer, spring washer and nut on each side. 5. Tighten the two nuts firmly against each other making sure that an even amount of thread is exposed on each side once done. The use of a thread locking agent is recommended. Check tightness of the nuts regularly.

Ducati 1100 Monster 2009 Exhaust Systems Slip-On Installation instructions

0

Filed Under (Ducati) by admin on 26-10-2010

download
1. 2. Unscrew the marked bolts and remove the stock muffler brakets (Figure 2). 3. Put the motorcycle on a side stand, we recommend a racing stand. Make sure, that surface is solid and flat. Unscrew the marked bolts from the mufflers chassis hanging brackets and remove the springs. Remove both mufflers with link pipes (Figure 1). REMOVAL OF STOCK EXHAUST SYSTEM
5 Figure 3 Figure 4 1. Insert the catalyst into the link pipe. Put a presson nut on the heat shield link pipe bracket and slide the link pipe with catalyst into the inlet side of the muffler and attach the springs. Repeat the process on another muffler (Figure 3, 4). WARNING! make sure that you put the longer part of the catalyst into the link pipe! INSTALLATION OF THE AKRAPOVIČ SLIP-ON EXHAUST SYSTEM www.akrapovic.com 22Nm 16ftlb 6 Figure 5 Figure 6 Correctly position and install the Akrapovič muffler brackets (Figure 5). WARNING! use Akrapovič bolt sealant on the threads of the stock bolts and tighten the bolts. 2. Correctly position the carbon-fiber clamps and slide them onto the mufflers – bear in mind the left offset of the carbon-fiber clamp viewed from the rear for right side and the right offset for the left side. WARNING! open the clamps slightly wider than the diameter of the outer sleeve of the mufflers – do not scrape them along the mufflers outer sleeve! (Figure 6, 7).