HARLEY DAVIDSON MOTORCYCLE SIREN INSTALLATION AND OPERATING INSTRUCTIONS

0

Filed Under (Harley Davidson) by admin on 15-03-2012

download
Before attempting installation, insure that the parts shown in the Kit Contents List (paragraph D.) have been included. To install the chassis, proceed as follows: 1. Insert two shock mount grommets into the large holes in each (2) mounting bracket (see figure 1). 2. Secure a mounting bracket to the chassis with two (each) #10 thread forming hex. head screws and #10 flat washers as shown in figure 1. Secure the other mounting bracket with like hardware. 3. Select a mounting location on the radio mounting platform which allows the siren cable to reach the motorcycle wiring harness, maintains the structural integrity of the motorcycle, and will not interfere with the safe operation of the motorcycle or the siren. 4. Using the supplied mounting template, scribe four drill position marks at the selected mounting location. CAUTION To avoid damage when drilling, ensure that both sides of mounting surface are clear of any parts or wires

HARLEY DAVIDSON TOUR-PAK SPOILER LIGHT KIT INSTALLATION MANUAL

0

Filed Under (Harley Davidson) by admin on 15-03-2011

download
Installation 1. If the motorcycle was previously equipped with a Tour-Pak Spoiler Light, disconnect the light wires from the motorcycle. 2. Remove the Tour-Pak Spoiler from the Tour-Pak and disassemble original light or chrome trim (as equipped). Save the original mounting hardware for later installation. 3. Attach light assembly to spoiler using 10-24 x 7/8 in. long screws. 4. See Figure 1. Route light wires through 3/8 in. hole in Tour-Pak lid. Attach spoiler to Tour-Pak lid using original hardware removed in step 2. 5. See Figure 1. Attach the wires to the inside of the Tour- Pak with adhesive backed clips as shown. Route wires out front left corner of Tour-Pak bottom and support wires inside Tour-Pak bottom with the remaining adhesive backed clips as needed. Wires will exit out the bottom of the Tour-Pak through the antenna cable grommet. NOTE On Chopped Tour-Paks drill a 3/8 in. hole in the front left corner of the Tour-Pak bottom. Route the spoiler light wires through this hole for connection to the main motorcycle wiring. 6. On 1994 and later models, proceed to step 7 for wire connection instructions. On 1993 and earlier models, go to step 11 for wire connection instructions. WIRING INSTRUCTIONS FOR 1994 AND LATER MODELS 7. Remove the seat and locate the accessory circuit connector. Route the light wires along the frame and secure with cable straps from kit. 8. Refer to the Deutsch connector section in a 1994 or later FLT Service Manual and assemble the spoiler wires into the socket connector half supplied with the LED assembly. The wire terminals shall be inserted in the connector half as follows: WIRE COLOR CODECONNECTOR CAVITY Blue 1 Red/yellow 2 Sealing plug 3 Black 4 9. Remove the plug from the accessory connector located under the seat (connector number [4A] in wiring diagram in Service Manual). Connect wire from spoiler. Turn on ignition switch and test the spoiler light operation with taillight and brake light. 1 WARNING Always connect the positive battery cable first. If the positive cable should contact the ground with the negative cable installed, the resulting sparks may cause a battery explosion resulting in personal injury. 10. Reattach battery