Suzuki GSX1000R 465 SeriesSingle Shock Supplement

0

Filed Under (Suzuki) by admin on 13-02-2011

download
1. One set of the shouldered sleeves with O-rings should be installed in the shock eye. If not, insert sleeves with O-rings in the shock eye (see figure 1). 2. Mount the shock as you would your stock shock per your authorized shop manual noting the following; Make sure the shock is mounted with the rebound adjustment at the bottom and facing the right side of the motorcycle and the nitrogen pressure valve is facing forward. Tighten the shock bolts to the proper torque specifications (refer to your manual). Caution: The installed spring length must never be set shorter than 133mm (5.25″) or shock damage may occur

Yamaha XV-19 Raider 465 Series Single Shock Supplement

0

Filed Under (Yamaha) by admin on 13-02-2011

download
Mount the shock as you would your stock shock per your authorized shop manual (with the rebound adjustment at the bottom) noting the following: n As you mount the shock, feed the Remote Adjustable Pre-Load adjuster towards the rear (see figure 2) and to the right side of the swingarm (see figure 3) . n Do not loosen or attempt to rotate the line between the shock and the adjuster. n Make sure the shock rebound adjustment is toward the rear and facing the right side of the motorcycle and the nitrogen pressure valve is facing down. n Tighten shock bolts to the proper torque specifications (refer to your manual). n Locate the EXUP valve servo mounting bracket, specifically the two bolts used to secure it to the frame (see figure 4) . They below the seat on the right hand side of the motorcycle. n Now either mount the adjuster to the supplied mounting bracket using the supplied M6-1.0X8mm SHCS fasteners and torque them to 80-90 in/lbs (9-10 N-m), then mount the bracket and adjuster to the bike using two EXUP valve servo mounting bolts (as shown in figure 5) – or – mount the adjuster bracket to the frame using those two bolts, then mount the adjuster to the bracket (may require removal of exhaust stay). n Using the supplied zip-ties, secure the hydraulic line away from any moving parts or heat sources.