FC designed and built solely for Victory Motorcycles Installation

0

Filed Under (Victory) by admin on 31-10-2010

download
1. Remove gas tank as per service manual procedure 2. Disconnect negative lead from battery 3. Determine a location for the VFC III unit. Suggested locations are as follows: on left or right side under the covers, on top or side of battery, on inside of the side covers, on PCM or under seat 4. Locate rear injector, disconnect factory connection using care not to break it, the red tab must be lifted first and then push the release to remove plug. Plug it into the female end of the VFC, Then plug the male end of the VFC into the injector. 5. Locate connection of front jumper harness- it is located on the right side of frame – in the center of air box. Disconnect and plug appropriate VFC connectors in place. 6. Zip tie harness so that it is free from being contacted 7. Install gas tank and connect ground terminal of VFC along with the factory ground lead. Note, On Vegas, Kingpin, Jackpot & Hammer Models. Be sure not to pinch VFC harness under rear tank mounting bracket, the harness must run on the side of or under the frame in this area as not to contact the rear tank mount. 8. Turn the motorcycle key to the “ON” position, after fuel pump cycles the Green / Red lights will flash and will remain flashing until an injector signal is detected, this occurs when the M/C is started. Once running the green will scroll for 4 seconds and then turn solid until another circuit is activated. Some 2000-20001 bikes will not light the box until started. The module controls your basic fuel adjustments and your fuel delivery for the Nitrous when activated. The following functions and colors that represent them are as follows. Basic Module description and adjustments ; the module has 3 button adjustments, Center is the mode selector, this scrolls through and chooses the feature that you want to adjust. To the left of it is the button in which minus’s in value the selected feature. To the right of the mode button is the plus button which makes the feature selected go higher in value. If a fuel feature is selected the minus button will diminish fuel down to the lowest level of the current download and plus will add fuel up to the maximum amount calibrated into the module. There are 8 LED lights on the front panel with 15 points of adjustment ranging from 0 to 8 in increments of .5 or 1/2 . Ex. 1 – 1.5 – 2 – 2.5 – 3 – 3.5 – 4 – 4.5 – 5 – 5.5 – 6 – 6.5 – 7 – 7.5 – 8