1,000 POUND CAPACITY MOTORCYCLE / ATV LIFT RML-600 INSTALLATION AND OPERATION MANUAL

0

Filed Under (Tips and Review) by admin on 25-11-2010

download
6 RML-600 Instructions 1. Center load on table – 1000 lb. maximum. 2. Connect to 100 PSI maximum shop air. 3. Keep safety bar in position at all times – except when lowering. 4. Keep hands and tools from under carriage. 5. Do not mount table when in elevated position. 6. Do not ride vehicle onto lift. 7. Lift must be in the lowered position when moving. 8. Only trained persons should operate Air Lift. 9. The working area should be sufficiently lit. 10. Foot controller should be at least 3 feet away from Air Lift during raising and lowering operation. 11. Lift is recommended for indoor use only. nstallation Instructions The Cycle Vise mounts directly onto the RML-600. Align two inside holes of the fixed clamp over the existing vise hole pattern as shown. Align the moveable clamp with the locating corner hole. CYCLE VISE
8 1. Insert pipes from extension panel package through holes in lift table. 2. Mount panels on ends of pipe on each side of table. With ramp hole to outside. 3. Insert M8 BOLTprovided through holes in each end of pipe. 4. Secure ramp extensions to ramp with bolts provided. Make sure ramp hooks are positioned on the outside. 5. Stabilization bar directions – Unscrew cap from one of the ends of the stabilization pipe. 6. Insert bolt in drilled out hole and tighten with nut. Slide pipe through the stationary square tubing on the lift legs. Insert the other bolt, tighten down with nut. Put on the other cap and tighten. Installation Instructions (Optional) 12″ Side Extensions
9 POSITION THE 13″ EXTENSION OVER THE EXISTING TABLE AS SHOWN AND ATTACH WITH FOUR M8 CAPSCREWS, NUTS AND LOCK WASHERS PROVIDED. EYE BOLTS ARE ALSO PROVIDED WITH THE EXTENSION KITAND MAYBE INSTALLED AS SHOWN USING M8 HEX NUTS AND LOCKWASHERS