DAZON RAIDER CLASSIC OWNER'S MANUAL

0

Filed Under (Dazon) by admin on 28-11-2010

download
Tires: Use a gauge to check the air pressure. Adjust if needed. Also look for signs of damages or excessive wear. z Nuts & Bolts : Check the wheels to see that the axle nuts are tightened. Use a wrench to make sure all accessible nuts, bolts, and fasteners are tight. z Underbody & Exhaust System: Check for and remove any dirt, vegetation or other debris that could be fire hazard or interfere with the proper operation of the BUGGY. z Air Cleaner Housing Drain Tube: Check for carbon deposits in the drain tube. If necessary, clean the tube and check the air cleaner housing. z Leaks, Loose Parts : Walk around your BUGGY and look for anything that appears unusual, such as a leak or loose cable. z Lights : Make sure the headlight, brake light and taillight are working properly. z Throttle : Check the free play and adjust if needed. Press the throttle to make sure it moves smoothly without sticking, and snaps back automatically when it is released. z Brakes : Press the rear brake pedal several times, check for proper brake pedal free play. Make sure there is no brake fluid leakage. z Engine Stop Button : When engine is running, press and hold the Engine Stop Button for two seconds. Make

Kawasaki 440/ 550 Engine Removal and Installation

0

Filed Under (Kawasaki) by admin on 25-10-2010

download
1.1 (Above) Remove the two retaining straps, disconnect the battery and remove it from the hull. Disconnect the negative (black) cable first, then the positive (red). Step 2 Exhaust Removal 2.1 (Below) Remove the exhaust hose from the end of the pipe. Remove the water line from the pipe and the head. 2.2 (Below) Remove the water by-pass line from the pipe. 2.3 (Below) Remove the four 10mm nuts / bolts from the exhaust manifold and bracket. Remove the exhaust pipe from the hull. Step 3 Engine Removal 3.1 (Below) Remove the three 10mm bolts securing the PTO shield and remove it. Remove the two 10mm bolts securing the flywheel electrical wire cap. Open the cap and disconnect the harness. NOTE: DO NOT CUT THE WIRES! 3.2 (Below) Disconnect the starter positive wire at the relay box with a 10mm socket