HARLEY-DAVIDSON DYNASTRAIGHTSHOT HS SLIP-ON INSTALLATION Manual

0

Filed Under (Harley Davidson) by admin on 17-03-2012

download
1. Before removing the stock exhaust system note orientation particularly of the support bar between the two muffl er bodies (Figure 1) and the muffl er clamps. If necessary, using tape or another easily removable means, note the orientation on the stock support to ease re-installation. 2. Remove the four 1/2″ lock nuts that hold the support bar to the stock muffl ers and remove the stock support bar and bolts (set the nuts. bolts and support bar aside as they will be used later). 3. Using the 9/16″ deep socket, loosen the clamps holding the muffl ers onto the head pipes and remove the muffl ers from the head pipes. NOTE: May require assistance and the use of penetrating oil. 4. The stock muffl er clamps may be re-used. However Vance & Hines recommends replacing them with new clamps (Harley part number 65283-94). If using the stock clamps, be sure the T-Bolt does not twist out of the groove during tightening. This could allow the clamp to loosen with use

TOYOTA FJ CRUISER – FRONT BUMPER INSTALLATION INSTRUCTIONS

0

Filed Under (Toyota Manuals) by admin on 23-09-2011

download
Before beginning installation, assure that vehicle has been pulled forward into work-area with the wheels straight and that the ground is level. The clearances around the FJ bumper are critical to proper installation and fitment. Moving vehicle with wheels turned causes slight frame twist preventing ease of removal of OE bumper and nstallation of new bumper without issue. Make sure you have plenty of room to work around front of vehicle. Open the hood at this time, you will need to see down through the inner-body core-support while removing your OE bumper and installing your Body Armor FJ Bumper. Step 2 a. Unpack bumper using staple puller to remove staples. Save all packing materials and take care not to tear cartons. b. Remove hardware and misc.parts. Check parts/hardware list to confirm all parts and necessary hardware are included. c. It’s a good idea to spray all OE attaching hardware at this time with penetrating oil before beginning removal of OE bumper. This will ease removal as well as to help assure that none of the bolts’ / nuts’ threads are damaged during removal. Use extra caution when working with the bumper mounting studs & nuts. Step 3 a. Begin removing OE bumper following instructions and photos on the following page for detailed descriptions and references. When done, proceed to Step 4 here.

Incoming search terms:

2009 VULCAN 1700 HEAT SHIELD KITS INSTALLATION MANUAL

0

Filed Under (Kawasaki) by admin on 25-10-2010

download
Installation Procedure Refer to the appropriate sections of the Service Manual for information and procedures related to parts removal and installation. NOTE: Cover the frame with tape on the left and right o sides (right side shown, left side similar) to prevent scratches during shield installation Remove and discard upper left and upper • right radiator screen mount screws (right side shown, left side similar). Install the heat shield along the upper edge • of the radiator and attach the shield and the screen with the radiator screen mount screws provided in the kit Remove the tape from the frame rails. • Install the clutch hose in the clamp on the left • frame tube. Front Cylinder Exhaust Cover NOTE: Apply penetrating oil to the exhaust cover o clamp screws prior to loosening. Loosen the exhaust pipe cover clamp screws. • Remove and discard the exhaust cover. •