Ducati 1100 Monster 2009 Exhaust Systems Slip-On Installation instructions

0

Filed Under (Ducati) by admin on 26-10-2010

download
1. 2. Unscrew the marked bolts and remove the stock muffler brakets (Figure 2). 3. Put the motorcycle on a side stand, we recommend a racing stand. Make sure, that surface is solid and flat. Unscrew the marked bolts from the mufflers chassis hanging brackets and remove the springs. Remove both mufflers with link pipes (Figure 1). REMOVAL OF STOCK EXHAUST SYSTEM
5 Figure 3 Figure 4 1. Insert the catalyst into the link pipe. Put a presson nut on the heat shield link pipe bracket and slide the link pipe with catalyst into the inlet side of the muffler and attach the springs. Repeat the process on another muffler (Figure 3, 4). WARNING! make sure that you put the longer part of the catalyst into the link pipe! INSTALLATION OF THE AKRAPOVIČ SLIP-ON EXHAUST SYSTEM www.akrapovic.com 22Nm 16ftlb 6 Figure 5 Figure 6 Correctly position and install the Akrapovič muffler brackets (Figure 5). WARNING! use Akrapovič bolt sealant on the threads of the stock bolts and tighten the bolts. 2. Correctly position the carbon-fiber clamps and slide them onto the mufflers – bear in mind the left offset of the carbon-fiber clamp viewed from the rear for right side and the right offset for the left side. WARNING! open the clamps slightly wider than the diameter of the outer sleeve of the mufflers – do not scrape them along the mufflers outer sleeve! (Figure 6, 7).