2008 Harley Davidson Touring models with an electronic throttle Grips Installation manual

0

Filed Under (Harley Davidson) by admin on 08-03-2012

download
1. Using a sharp knife, remove the rubber from your current grip by carefully cutting it away from the existing plastic throttle sleeve. The rubber that is adhered to the plastic sleeve must be ” shaved” resulting in a smooth plastic sleeve with no rubber. 2. Apply glue to the throttle sleeve. Use about 1/4 of the tube of glue on each side. Most of the glue should be applied to the end of the sleeve away form the throttle housing. 3. Slide the grip on to the throttle sleeve with one strong push. Use a rubber mallet if needed. Be sure not to get any of the glue into the space between the throttle sleeve and the throttle housing as well as the space between the throttle sleeve and the handlebar. *Wipe up any excess glue immediately

HARLEY DAVIDSON VRSCD SADDLEBAG MOUNTING KIT INSTALLATION MANUAL

0

Filed Under (Harley Davidson) by admin on 14-04-2011

download
INSTALLATION Prepare Bike for Hardware Installation 1. Use a suitable lift to support the motorcycle under the frame until the rear suspension is fully extended. NOTE To remove the tether from the hole in the frame, reach under the frame tube to align the metal tee (located on the end of the seat tether) with the tether cable. 2. See Figure 1. Unlatch and open seat. Remove tether (4) by sliding small clip (3) sideways through hole in frame. NOTE To remove the tubular plastic seat-hinge sleeve from the hinge, turn the sleeve to reveal the slotted length. Push on the slot with your finger to pop the sleeve off the hinge pins. Closing the seat slightly allows the sleeve to fall from the hinge-side of the seat, so be prepared to catch the sleeve. 3. Remove plastic sleeve (2) from hinge pins (1) and slide pins toward rear of bike. Remove seat. 2 1 4 3 is 00449 1. Hinge 2. Sleeve 3. Clip 4. Remove tether from frame Figure 1. Remove Seat 3 1 2 is 00450 1. Grabstrap 2. Passenger Pillion 3. Screw and Washer Figure 2. Remove Passenger Pillion 4. See Figure 2. Remove screw and washer (3) securing passenger pillion to frame. Slide pillion under grabstrap (1) and forward to disengage from tongue to remove. Save pillion mounting screw and washer for later use