HARLEY DAVIDSON TIMKEN BEARING CONVERSION TOOL INSTALLATION MANUAL

0

Filed Under (Harley Davidson) by admin on 10-03-2011

download
2-ton press (must be square to within .010″, ram to table) Inch-lb torque wrench Foot-lb torque wrench T15 TORX® drive socket (for inch-lb torque wrench) 5/32 inch hex drive socket (for inch-lb torque wrench) 5/16 inch hex drive socket (for foot-lb torque wrench) 5/64 inch hex key wrench 1/16 inch hex key wrench 3/8 inch drive hand drill small tap handle (suitable for #8-32 tap) Tapping Fluid Press Fit Lube (non-drip) Loctite® 620 threadlocker and sealant The rider’s safety depends upon the correct installation of this kit. Use the appropriate service manual procedures. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00333a) NOTE This instruction sheet references service manual information. A service manual for your model motorcycle is required for this installation and is available from a Harley-Davidson Dealer. Kit Contents See Figure 21 and Table 3. If replacement parts are needed contact JIMS® at 805-482- 6913 or INSTALLATION 1. Remove and disassemble the engine as necessary to remove the left side engine case. Bearings and seals must be removed from the left case. Refer to the service manual for the disassembly procedures. 2. Use an appropriate solvent to clean the left engine case. Also clean the bearing sleeve (1) supplied in the kit. 3. Apply Loctite 620 to the smaller inside diameter portion of the left case bearing bore. 4. See Figure 1. Apply Loctite 620 using a cotton swab to the smaller portion of the outside diameter (2) surface of the bearing sleeve (1). 5. Apply a spare amount of non-drip press fit lube (3) to the larger outside diameter of the bearing sleeve. 6. See Figure 2. Fit the bottom locater plate (1) to the to the outside of the case over the bearing bore. The word “BOTTOM” will be at the bottom of the case when installed at the 6 o’clock position

Harley-Davidson Valves, Guides And Seats Installation

0

Filed Under (Harley Davidson) by admin on 31-10-2010

download
1: Clean carbon from old guide O.D. before removal. 2: Guide to head press fit .0015″ / .002″ (head smaller than guide). 3: Heat head to approximately 200° – 250° F. 4: Install the guide at room temperature (Head hot & Guide at room temperature). 5: Let head cool to room temperature before final sizing of the bore. 6: Determine desired clearance valve to guide. Recommended clearance Shovel Head with cast iron guides Intake .001″ – .0015″ Exhaust .0015″ – .002″ (Ampco-45 add .001″) 7: Select the correct plug gage by adding the valve stem diameter and clearance desired for the finish diameter. 8: Select a plug gage .0005″ under finish size for the other end of the handle. 9: Finish hone the bore to size, check the size as you hone with the -.0005″ under size pin gage, finish hone to size with the finish plug gage pin. 10: Cut or Grind the seats, lap the valves to seats and check valve seat concentricity before assembling valve springs. 11: Use a good assembly lube, S’NS works great. 12: Use valve stem seals. Factory OE seals will stay tight with guide top size +.005″ to -.015″ from published size. 13: After the head is assembled and still on the bench check for any leakage valve to seat