1999-2002 SUZUKI SV 650 OWNER'S MANUAL

0

Filed Under (Suzuki) by admin on 26-02-2011

download
FUEL, ENGINE OIL AND COOLANT RECOMMENDATION FUEL Your motorcycle requires regular unleaded gasoline with a minimum pump octane rating of 87 ((R+M)/2 method) . In some areas,the only fuels that are available are oxygenated fuels. Oxygenated fuels which meet the minimum octane requirement and the requirements described below may be used in your motorcycle without jeopardizing the New Vehicle Limited Warranty or the Emission Control System War- ranty. NOTE: Oxygenated fuels are fuels which contain oxygen-carrying additives such as MTBE or alcohol. Gasoline Containing MTBE Unleaded gasoline containing MTBE (Methyl Tertiary Butyl Ether) may be used in your motorcycle if the MTBE content is not greater than 15%. This oxygenated fuel does not contain alcohol. Gasoline/Ethanol Blends Blends of unleaded gasoline and ethanol (grain alcohol), also known as GASOHOL, may be used in your vehicle if the ethanol content is not greater than 10%. Gasoline/Methanol Blends Fuels containing 5% or less methanol (wood alcohol) may be suitable for use in your motorcycle if they contain co-solvents and corrosion inhibitors. DO NOT USE fuels containing more than 5% methanol under any circumstances. Fuel system damage or motorcycle performance problems resulting from the use of such fuels are not the responsibility of Suzuki and may not be covered under the New Vehicle Limited Warranty or the Emission Control System Warranty . Fuel Pump Labeling In some states, pumps that dispense oxygenated fuels are required to be labeled for the type and percentage of oxygenate, and whether important additives are present . Such labels may provide enough information for you to determine if a particular blend of fuel meets the requirements listed above. In other states, pumps may not be clearly labeled as to the content or type of oxygenate and ad- ditives . If you are not sure that the fuel you intend to use meets these requirements, check with the service station operator or the fuel suppliers

Incoming search terms:

1999-2002 SUZUKI SV650 OWNER'S MANUAL

0

Filed Under (Suzuki) by admin on 12-12-2010

download
Gasoline/Ethanol Blends Blends of unleaded gasoline and ethanol (grain alcohol), also known as GASOHOL, may be used in your vehicle if the ethanol content is not greater than 10%. Gasoline/Methanol Blends Fuels containing 5% or less methanol (wood alcohol) may be suitable for use in your motorcycle if they contain co-solvents and corrosion inhibitors. DO NOT USE fuels containing more than 5% methanol under any circumstances. Fuel system damage or motorcycle performance problems resulting from the use of such fuels are not the responsibility of Suzuki and may not be covered under the New Vehicle Limited Warranty or the Emission Control System Warranty . Fuel Pump Labeling In some states, pumps that dispense oxygenated fuels are required to be labeled for the type and percentage of oxygenate, and whether important additives are present . Such labels may provide enough information for you to determine if a particular blend of fuel meets the requirements listed above. In other states, pumps may not be clearly labeled as to the content or type of oxygenate and ad- ditives . If you are not sure that the fuel you intend to use meets these requirements, check with the service station operator or the fuel suppliers. d of. ; NOTE: • * To help clean the air, Suzuki recommends that you use the oxygenated fuels . • * Be sure that any oxygenated fuel you use has octane ratings of at least 87 pump octane ((R+M)/2 method) . • * If you are not satisfied with the driveablity or fuel economy of your motorcycle when you are using an oxygenated fuel, you should switch back to regular unleaded gasoline . • * If engine pinging is experienced, substitute another brand as there are differences between brands . A CAUTION Spilled gasoline containing alcohol can harm your motorcycle. Alcohol can damage painted surfaces. Be careful not to spill any fluid when filling the fue

Baja BA 250 ATV OWNER'S MANUAL

0

Filed Under (Bajaj) by admin on 26-11-2010

download
FUEL AND OIL FUEL Proper fuel is very important for the engine. Ensure there is no dust, dirt, or water which has mixed in the fuel. Use regular unleaded gasoline with an octane number 90 or higher. ENGINE OIL Your 250cc ATV has a four-stroke engine. Please use oil as described in the chart below. By using prescribe oil, you will realize the best lubrication for engine. Use the chart to select a viscosity rating based on the temperature range in your area. NOTE: In very cold weather (below 5°F (-15°C), use SAE10W-30 for good starting and smooth operation. SAE 10W-30 SAE 20W-40 ENGINE TEMP. °C °F -30 -22 40 104 -10 14 0 32 10 50 20 68 30 86 -20 4 FUEL AND OIL 8 LOCATION OF LABELS Read and follow all of the warnings labels on your ATV. Make sure you understand all the labels. Keep the labels on the ATV. Do not remove them for any reason. If a label comes off or becomes difficult to read, you should get a replacement by contacting BAJA INC. 1 – Red Light – Reverse indicator Light illuminates when ATV is in Reverse. 2 – Green Light – Neutral indicator Light illuminates when ATV is in Neutral. 3 – Ignition key switch – Turn right (CW) “RUN”, Turn left (CCW) “OFF”. ATV will only start when ignition key is turned to the “RUN” position. Make sure ignition key switch is in the “OFF” position when not in use

Incoming search terms:

YAMAHA VMX12W1 (C) OWNER'S MANUAL

0

Filed Under (Yamaha) by admin on 25-11-2010

download
Brake pedal The brake pedal is on the right side of the motorcycle. To apply the rear brake, press down on the brake pedal. EAU13060 Fuel tank cap To remove the fuel tank cap 1. Push the levers on the left and right side of the rider seat backrest as shown and slide the rider seat backrest forward. 2. Insert the key into the lock, and then turn it 1/4 turn clockwise. The lock will be released and the fuel tank cap can be removed. To install the fuel tank cap 1. Insert the fuel tank cap into the tank opening with the key inserted in the lock and with the mark on the cap facing forward. 2. Turn the key counterclockwise to the original position, and then remove it. 3. Slide the rider seat backrest rearward and push it down. NOTE: The fuel tank cap cannot be installed 1. Brake pedal 1. Opening lever 1. Unlock.
INSTRUMENT AND CONTROL FUNCTIONS 3-7 2 3 4 5 6 7 8 9 unless the key is in the lock. In addition, the key cannot be removed if the cap is not properly installed and locked. WARNING EWA10130 Make sure that the fuel tank cap is properly installed before riding. EAU13211 Fuel Make sure that there is sufficient fuel in the tank. Fill the fuel tank to the bottom of the filler tube as shown. WARNING EWA10880 * Do not overfill the fuel tank, otherwise it may overflow when the fuel warms up and expands. * Avoid spilling fuel on the hot en- gine. CAUTION: ECA10070 Immediately wipe off spilled fuel with a clean, dry, soft cloth, since fuel may deteriorate painted surfaces or plastic parts. EAU13300 CAUTION: ECA11400 Use only unleaded gasoline. The use of leaded gasoline will cause severe damage to internal engine parts, such as the valves and piston rings, as well as to the exhaust system. Your Yamaha engine has been designed to use regular unleaded gasoline with a pump octane number [(R+M)/2] of 86 or higher, or a research octane number of 91 or higher. If knocking (or pinging) occurs, use a gasoline of a different brand or premium unleaded fuel. Use of unleaded fuel will extend spark plug life and reduc

YAMAHA PW 50Y SPECIFICATION AND OWNER'S MANUAL

0

Filed Under (Yamaha) by admin on 19-11-2010

download
Rear brake lever The rear brake lever is located on the left handlebar grip. To apply the rear brake, pull this lever toward the handlebar grip. EAU13182 Fuel tank cap To remove the fuel tank cap, turn it counterclockwise, and then pull it off. To install the fuel tank cap, insert it into the tank opening, and then turn it clock- wise. WARNING EWA11091 Make sure that the fuel tank cap is properly closed after filling fuel. Leaking fuel is a fire hazard. EAU13221 Fuel Make sure there is sufficient gasoline in the tank. WARNING EWA10881 Gasoline and gasoline vapors are extremely flammable. To avoid fires and explosions and to reduce the risk of injury when refueling, follow these instructions. 1. Before refueling, turn off the engine and be sure that no one is sitting on the vehicle. Never refuel while smoking, or while in the vicinity of sparks, open flames, or other sources of ignition such as the pilot lights of water heaters and clothes dryers. 2. Do not overfill the fuel tank. When refueling, be sure to insert the pump nozzle into the fuel tank filler hole. Stop filling when the fuel reaches the bottom of the filler tube. Because fuel expands when it heats up, heat from the engine or the sun can cause fuel to spill out of the fuel tank. Your Yamaha engine has been designed to use regular unleaded gasoline with a pump octane number [(R+M)/2] of 86 or higher, or a research octane number of 91 or higher. If knocking (or pinging) occurs, use a gasoline of a different brand or premium unleaded fuel. Use of unleaded fuel will extend spark plug life and reduce maintenance costs. Gasohol There are two types of gasohol: gasohol containing ethanol and that containing methanol. Gasohol containing ethanol can be used if the ethanol content does not exceed 10% (E10). Gasohol containing methanol is not recommended by Yamaha because it can cause damage to the fuel system or vehicle performance problems

YAMAHA TW125 SERVICE MANUAL

0

Filed Under (Yamaha) by admin on 19-11-2010

download
Dimensions: Overall length Overall width Overall height Seat height Wheelbase Minimum ground clearance Minimum turning radius 2,140 mm , 810 mm 1,120 mm , 805 mm 1,330 mm , 260 mm 2,100 mm Basic weight: With oil and full fuel tank 125 kg Engine: Engine type Cylinder arrangement Displacement Bore stroke Compression ratio Compression pressure (STD) Starting system Lubrication system: Air-cooled 4-stroke, SOHC Forward-inclined single cylinder 0.124 L (124 cm3) 57.0 48.8 mm 10.0 : 1 1,200 kPa (12.0 kg/cm2, 12.0 bar) at 1,000 r/min Electric starter Wet sump Oil type or grade: Engine oil API standard: “SE” or higher grade ACEA standard: G4 or G5 Periodic oil change With oil filter replacement Total amount 1.0 L 1.1 L 1.3 L Air filter: Wet type element Fuel: Type Fuel tank capacity Fuel reserve capacity Regular unleaded gasoline 7.0 L 1.0 L 2-2 GENERAL SPECIFICATIONS SPEC Model TW125 Carburetor: Type/quantity Manufacturer Y24P/1 TEIKEI Spark plug: Type Manufacturer Spark plug gap DR8EA NGK 0.6 0.7 mm Clutch type: Wet, multiple-disc Transmission: Primary reduction system Primary reduction ratio Secondary reduction system Secondary reduction ratio Transmission type Operation Gear ratio 1st 2nd 3rd 4th 5th Spur gear 74/20 (3.700) Chain drive 50/14 (3.571) Constant mesh 5 speed Left foot operation 36/16 (2.250) 31/21 (1.476) 27/24 (1.125) 25/27 (0.926) 23/29 (0.793) Brake: Front brake type operation Rear brake type operation Single disc brake Right hand operation Drum brake Right foot operation Suspension: Front suspension Rear suspension Telescopic fork Swingarm (Monocross) Shock absorber: Front shock absorber Rear shock absorber Coil spring/Oil damper Coil gas spring/Oil damper Wheel travel: Front wheel travel Rear wheel travel 160 mm 150 mm Electrical: Ignition system Generator system Battery type Battery capacity C.D.I. C.D.I. magneto GM 7CZ-3D 12 V 7 AH Headlight type: Bulb type Bulb wattage quantity:

Incoming search terms:

Incoming search terms: