Honda GL1000 Timing Belts Removal / Installation Manual

0

Filed Under (Honda) by admin on 08-04-2011

download
Turn engine as described above until the T-1 mark aligns with engine block marks (it looks a little ‘out’ on the photo, it’s the angle). AND (this is important) the pulley marks align with the marks on the engine cover like here on LEFT side (seen from sitting on bike … remember). and RIGHT side. Mark this position on the central pulley and engine block. Now release the tensioner bolts. (*) And remove the belt. (*) (*) When you do that the right pulley (photo-left) will ‘wander/turn’ out of position when you remove the belt, as it is ‘riding’ on cam ‘slope’ (which is under the influence of the valve springs). Don’t worry. One thing you can do to calm your nerves and keep it in position: put the new belt loosely over the pulley and holding the pulley in the CORRECT POSITION (marks aligned) ‘strip’ a spanner to the frame. Do not use the spanner to turn the pulley. Use your hands … then ‘lock’ it with the spanner. (Make absolutely sure you do not turn (release/loosen) the bolt). And, here’s a nifty trick posted by Mooseheadm5 in another thread: “..one thing that made it super easy (and 3 reduced the anxiety level quite a bit) was that I loosened the tappet adjusters all the way [...snip...] you do not have to fight the valve springs much, plus the cams do not want to snap back or forward so you do not necessarily need to use Octane’s zip-tied wrench trick.” – Thanks, Moosehead . Release left tensioner bolts . Remove belt. Put on new belt. Check the tensioners or ‘tension rollers’. You may think they are ‘fine’: they ‘roll’ and don’t make funny sounds? You won’t know until you’ve had a set of new rollers in your hands. They should be real ‘tight’ as a set of new roller bearings … which I think they are, in fact. If they appear ‘dry’ or make any sounds; renew them and get rid of that high pitched whining sound associated with ‘dry’ rollers. This is how they go on left side (remember…photo-right). And the spring gets attached . … Pulleys in correct position (crank pulley and cam pulley) . … Left belt tight at the bottom … Tension roller loosely attached (let the spring do the tension). (On photo it is not on yet … ooops.

Incoming search terms:

Incoming search terms: