HARLEY DAVIDSON TRUNK MOUNT FLAG KITS INSTALLATION MANUAL

0

Filed Under (Harley Davidson) by admin on 22-03-2011

download
Installation Water may enter Tour-Paks/saddlebags with flag mast installed during inclement weather. Attaching a flag mast to a Tour-Pak or saddlebag without wear pads in place may result in damage to the Tour-Pak or saddlebag exterior. Periodically check to ensure the flag mast remains in contact with wear pads. 1. See Figure 1. Remove adhesive backing from wear pad and place on area where mast base will hit the painted portion of the Tour-Pak and/or saddlebag. Attach flag mast to Tour-Pak or saddlebag as shown. Attaching flag mast to Tour-Pak or saddlebag without rubber pads in place may result in damage to exterior of Tour-Pak or saddlebag. 2. Cut the self adhesive rubber pad in half. Remove the backing from the rubber pads and place on the inside of the Tour-Pak or saddlebags on each side of the flag mast as shown. CAUTION CAUTION CAUTION INSTRUCTIONS -J01143 REV. 11-20-01 TRUNK MOUNT FLAG KITS ® Kit Numbers 94612-98, 94617-98, 94618-98, 94626-98 Figure 1. Flag mast installed on Tour-Pak Place wear pad on area where mast base will hit the painted portion of the Tour-Pak and/or saddlebag i01121 Figure 2. Rubber pads installed on interior of Tour-Pak

HONDA VTX BRAKE CALIPER COVER INSTALLATION INSTRUCTIONS

0

Filed Under (Honda) by admin on 29-01-2011

download
1. Clean caliper face with rubbing alcohol making sure it is free of grease, oil & debris. 2. If the caliper is below 70 degrees, warm it with a hair dryer. 3. Peel off the self-adhesive backing, press into place & firmly hold for 30 seconds

Harley-Davidson Caliper Cover Installation Instructions

0

Filed Under (Harley Davidson) by admin on 29-12-2010

download
1. Clean caliper face with rubbing alcohol making sure it is free of grease, oil & debris. 2. If the caliper is below 70 degrees warm it with a hair dryer. 3. Peel the self-adhesive backing and press into place firmly and hold for 30 seconds

TRIUMPH ROCKET III CALIPER COVERS INSTALLATION INSTRUCTIONS

0

Filed Under (Triumph) by admin on 26-12-2010

download
1. Clean caliper face with rubbing alcohol making sure it is free of grease, oil and debris. 2. If the caliper is below 70 degrees warm it with a hair dryer. 3. Peel the self adhesive backing and press into place firmly and hold for 30 seconds. 4. Repeat with remaining cover if necessary.

TRIUMPH AMERICA AND SPEEDMASTER CALIPER COVER INSTALLATION INSTRUCTIONS

0

Filed Under (Triumph) by admin on 23-12-2010

download
INSTALLATION INSTRUCTIONS CALIPER COVER FOR TRIUMPH AMERICA & SPEEDMASTER #TA030 RIVCO 1. Clean caliper face with rubbing alcohol making sure it is free of grease, oil & debris. 2. If the caliper is below 70 degrees warm it with a hair dryer. 3. Peel the self-adhesive backing and press into place firmly and hold for 30 seconds