Harley-Davidson Auxiliary LED Brake Light Installation Manual

0

Filed Under (Harley Davidson) by admin on 28-03-2012

download
If you are mounting the lighthead on a Harley-Davidson® motorcycle box, use the existing wire hole. Drill your mounting holes so the wire hole (located very close to the mounting hole in the lighthead) will line up with the wires, but not interfere with the mounting holes. Since the lighthead can mount to any vehicle, this manual will cover mounting to a generic location. 1. Mark the location of the 2 mounting holes onto the mounting surface using the dimensions shown above, or remove the lens and use it as a template. Always check behind the mounting surface to be sure you will not interfere with any other vehicle components. 2. Drill the 2 mounting holes using a drill sized for a #6 sheet metal screw, then drill the 9/32″ wire access hole 5/16″ away from the mounting hole as shown. 3. Feed the wires through the wire hole then secure the brake light to the mounting surface with the supplied mounting hardware. 4. Wire the lighthead into your existing brake light wiring, matching the lighthead wire colors to the vehicle wire colors (see “Wiring”). WARNING! All customer supplied wires that connect to the positive terminal of the battery must be sized to supply at least 125% of the maximum operating current and FUSED at the battery to carry that load. DO NOT USE CIRCUIT BREAKERS WITH THIS PRODUCT!

Yamaha V-Star 650 Jet Kit REMOVAL AND INSTALLATION MANUAL

0

Filed Under (Yamaha) by admin on 16-01-2012

download
Remove the vacuum slide from the carburetor. • Remove the OEM needle and spacer, noting the order of assembly. • Counting from the top to the bottom, install the new Baron needle clip on groove #4 of the replacement Baron adjustable needle. • Reinstall the OEM spacer and washer. • Reinstall the vacuum slide along with the diaphragm spring. • Reattach the diaphragm cover and tighten its screws. Note: Verify that the slide maintains a full range of movement! • Drain the fuel from float bowl and remove the bowl cover. • Remove the new cap head Allen screws in place of the OEM Phillips head screws. • Repeat above steps for other OEM main jet and pilot jet, and replace them with Baron’s main and pilot jets. • Thoroughly clean the inside of the float bowl prior to reinstalling it. • Reassemble the carburetor by reversing the order of previous steps. Use thecarburetor. • Locate the fuel mixture plug on each carburetor; it will either be a screw head or a brass plug. If it is a screw head, skip to step c . If you see a brass plug with a small hole in the center, proceed as follows: a. With a 5/32″ drill bit, carefully and slowly drill through the fuel mixture plug for each carburetor. CAUTION: The fuel mixture screw is located directly beneath this plug. Be prepared to stop the drill and remove the bit the instant you break through the plug. b. Insert a self-tapping sheet metal screw into the drilled hole and remove the plug. 311 #1 Industrial Way – Fallbrook, CA 92028 – USA Phone: (760) 731-1200 Fax: (760) 731-1284 E-mail: tech@baronscustom.com Website: www.baronscustom.com Included in this kit: (2) Mikuni main jets, (2) pilot jets, (2) titanium needles, (2) clips, (8) cap head Allen screws Revision 2.0 c. With air/fuel screw now accessible, use a flat blade screwdriver to turn the screw clockwise until it seats, then carefully turn it counter-clockwise 3 turns. Refer to final step for assistance in fine-tuning the setting of the air/fuel adjustment screw. • Reinstall the OEM air filter assembly. • Check all vent lines, fuel lines, and linkage for any obstructions or blockage