Suzuki DRZ 400K Dual Sport Kit Installation Manual

0

Filed Under (Suzuki) by admin on 11-02-2012

download
DRZ 400 (Kick Start) Dual Sport Kit Installation Manual 1. Get a degree in Mechanical and Electrical Engineering. (Just kidding!) 2. Remove the side panels, seat, and gas tank. 3. Unplug the headlight from the stock wiring and remove. 4. Unplug the kill button from the stock wiring and remove (Photo 2). The connector is a gray two-conductor connector located under the fuel tank. Release detent on connector to separate. Kill switch connector Photo 2 5. Unplug the stock taillight and remove. Using a utility knife, trim the taillight mounting tabs flush with the underside of the fender. ΒΌ” Photo 3 Countersunk screw and bezel, 4 Places 6. Taillight Installation Position the taillight assembly so that the edge of the red taillight extends past the edge of the fender about 1/4″ as shown in Photo 3. With the taillight positioned as shown Photos 3 & 4 , transfer the four mounting hole locations into the bottom of the fender. Drill the mounting holes at 1/4″ diameter. Use the 6 x 16 mm counter-sunk fasteners and bezels for mounting the taillight

Incoming search terms:

2002 – 2003 Camry A/ C PERFORMANCE & DURABILITY IMPROVEMENT

0

Filed Under (Toyota Manuals) by admin on 28-10-2011

download
Start the engine. B. Inspect the compressor for a metallic rattle sound. a. Check if there is a metallic rattle sound from the compressor when the A/C switch is on. b. If a metallic rattle sound is heard, replace the compressor assembly. Please follow the instructions in the repair manual for compressor removal and replacement: V6 engine: page 55-50 L4 engine: page 55-57 C. Inspect magnetic clutch condition. a. Check the magnetic clutch for signs of overheating. b. If there are signs of overheating, replace the magnetic clutch. 2. Install Air Conditioner Wire. A. Remove instrument panel under cover sub-assembly No. 1, glove compartment door pad, instrument panel sub-assembly lower and heater to foot duct No. 1. B. Remove the cooler thermistor connector from the blower unit.

Incoming search terms:

Incoming search terms: