HARLEY DAVIDSON CRUISE CONTROL KIT INSTALLATION INSTRUCTIONS

0

Filed Under (Harley Davidson) by admin on 29-01-2011

download
INSTALLATION NOTE if the motorcycle is equipped with the optional Harley-Davidson Smart Siren, the main fuse MUST be removed BEFORE the alarm is activated. This WILL happen within 5 seconds of turning the ignition switch to the OFF position (except for HD- Japan models). If the main fuse is not removed promptly, the siren WILL SOUND. 1. Refer to the service manual and follow the instructions given to remove the main fuse. 2. For FLHT, FLHTC, FLHX, FLHXXX and FLTRX models: Remove the outer fairing per the instructions in the service manual. For FLHR models: Follow the instructions in the service manual to remove only the handlebar clamp shroud. Removing the nacelle is not necessary. a. Remove the windshield and headlamp door. Remove the headlamp housing assembly. b. Release the chrome trim strip at the top of the nacelle. c. Remove the two Phillips screws beneath the fork lock plate. d. Loosen the Phillips screw at the front of the handlebar clamp shroud, and the four acorn nuts on the side of the headlamp nacelle. e. Raise the shroud slightly, separate the nacelle halves and slide the shroud forward to remove it from the nacelle. NOTE Before disconnecting the handlebar switch wiring, note the wire routing. 3. For ALL models: Refer to the service manual. Disconnect the right-side handlebar MOLEX socket housing from the black six-way main harness pin housing [22B] inside the fairing or headlamp nacelle