Harley- Davidson Bagger Audio factory service manual for removal

0

Filed Under (Harley Davidson) by admin on 03-04-2012

download
POWER & SPEAKER HARNESS INSTALLATION- (Read electrical connections prior to connecting center power and ground wires) 1. Disconnect battery (negative cable first!) 2. Remove outer faring cover 3. Route long speaker wires from fairing area through tank channel to seat area. 4. Route one pair of speaker wires under each fender strut support; purple and purple and black wires to the right and green and green and black wires to the left. AMPLIFIER INSTALLATION- 1. Factory installed electronics will determine suggested placement of amplifier. 2. Position and attach amplifier to outer fairing support bars with supplied wire ties. (Electra/Ultra/Street Glide) BAGGER AUDIO™ LIDS INSTALLATION- Detach factory lid by removing the 2 screws holding the factory strap to inner lid and 5 small torque screws holding lid to factory latch assembly. (Consult factory service manual for further instructions) Remove metal strap from behind factory seal (This is the metal strap that the previous 5 small torque screws were removed from) Position metal strap in same location on your new lid. (If you purchased your product unpainted, you must install the supplied seal to your finished lid) Reattach BAGGER AUDIO™ LIDS by installing the 5 small torque screws in the same location as on the factory lid. (We suggest that you have an assistant hold the lid in place while attaching your new lids) Replace factory nylon Hinge straps with new nylon straps supplied in kit. Use metal straps and machined screws to secure the nylon hinge straps. 
 Place a small bead of silicone on the inside rim of the speaker basket to create a watertight seal between the inside of the lid and the speaker. 
 Install speaker into the bottom of the lid (not through the top opening) with supplied stainless screws and washers (4 per lid). Be sure to center speaker in lid opening to ensure proper speaker grill placement. Install speaker with terminals facing toward the front of the lid. One 1/4″ hole must be drilled in each bag. Holes can be positioned at the ownerʼs discretion. Place rubber grommet in drilled hole before running wires

ATV MOTORCYCLE Full Wave Audio Installation Manual

0

Filed Under (Tips and Review) by admin on 28-11-2010

download
If installing this system for use with existing marine stereo: Connect RCA Y adapter (sold separately) to music source cable and plug into Low Level outputs of the stereo. Do NOT use the included power switch. Attach the Amplifier Remote wire from stereo to the BLUE wire of the amplifier. The amplifier will now be turned on and off by your stereo. This step replaces the Power On/Off switch installation step. 2. Determine a location suitable for mounting the remote switches and speakers, paying close attention to clearance or obstructions. 3. Place tape over the desired speaker location and mark a center point. Use the speaker template(s) and mark the center of the 4 inch hole to be cut for each speaker. 4. Pre-solder both terminals of each speaker. 5. Using a 4″ hole saw, drill holes for each speaker. 6. Place a speaker in each hole and mark the mounting screw locations before drilling pilot holes. 7. Drill 1/8″ pilot holes for speaker mounting screws at the screw locations. 8. Position amplifier making sure to pick a location that has tolerance for drilling and for the depth (1 inch) of the mounting screws. You will secure the amplifier later. 9. Feed the red/black speaker wires from the amplifier through the speaker holes. 10. Place the red speaker wire from the amplifier against the small pre- soldered speaker terminal and flow the solder together with your soldering iron.