HARLEY DAVIDSON SCREAMIN' EAGLE "HEAVY BREATHER" PERFORMANCE AIR CLEANER KIT INSTALLATION INSTRUCTIONS

0

Filed Under (Harley Davidson) by admin on 02-02-2011

download
INSTALLATION To prevent accidental vehicle start-up, which could cause death or serious injury, disconnect battery cables (negative (-) cable first) before proceeding. (00307a) Disconnect negative (-) battery cable first. If positive (+) cable should contact ground with negative (-) cable connected, the resulting sparks can cause a battery explosion, which could result in death or serious injury. (00049a) 1. Refer to the service manual and follow the instructions given to remove the seat and disconnect the battery cables, negative (-) cable first. Retain all seat mounting hardware. When servicing the fuel system, do not smoke or allow open flame or sparks in the vicinity. Gasoline is extremely flammable and highly explosive, which could result in death or serious injury. (00330a) Original Equipment (OE) Air Cleaner Removal For carbureted models: Refer to the service manual and check the warm-slow idle speed adjustment before removing the OE air cleaner backplate. For EFI (fuel-injected) models: Have a Harley-Davidson dealer recalibrate the ECM prior to air cleaner installation. 2. Remove the air cleaner backplate following the instructions in the service manual. Retain the two breather screws (A) removed from the backplate (see Figure 1). The remaining parts can be discarded. 3. See Figure 1. Remove and discard induction module bracket (B). “Heavy Breather” Air Cleaner Installation NOTE When servicing the air cleaner, apply Loctite 243 (blue) to all threaded fasteners (both male and female threads). 4. Install the new O-rings (4) in the grooves around the breather screw holes on the carburetor or induction module side of the backplate (1 or 2)

MX And Enduro steering dampers Owners Manual

0

Filed Under (Tips and Review) by admin on 24-11-2010

download
setting The steering damper has three external setting possibilites, ie, setting of the damper valve, high- speed valve and sweep valve, which regulate the damping area (fig.2). Low speed valve Öhlins steering damper is delivered with the low speed valve set in a basic position that gives maximum basic damping. For enduro and motocross it is suitable to set the low speed in position 4-8, depending on the track and the rider. Turn clockwise to increase damping and counter clockwise to reduce it (fig.3). High speed valve The high-speed valve (fig.4) is set between 11/4 to 2 turns from the bottom position, suitable for enduro, motocross and off-road. WARNING! For all riding purposes the high-speed valve must be loosened at least 1 turn from the bottom. Otherwise the damping forces will become too high, making the ride hazardous. 5 3 High speed adjustment Steering damper body Link arm Sweep adjustment 4 Low speed adjustment Sweep adjustment Damping sweep controls Damping sweep controls (fig.8) are located on each side off the damper body. Damping is in position 2, (12 o´clock), when delivered from Öhlins. This setting is fitted for enduro, motocross and off-road riding