1980-2003 HARLEY DAVIDSON BARON TACHOMETER installation manual

0

Filed Under (Harley Davidson) by admin on 12-03-2012

download
1. Mount new Baron Tach on handlebar in your preferred position. Ideal location is between handlebar risers. If mounted off-center, you can rotate tach face back to vertical (or any position you desire) by first loosening tach unit’s set screw (found either in handlebar area of housing or underside of housing, depending on tach style), then unscrewing tach housing’s bezel, rotating the tach internals, re-installing the bezel and retightening the set screw. 2. Secure handlebar clamp by first tightening the rear, flat side of clamp all the way down, and then tighten the tapered front side of clamp until tach does not rotate. There should be a small gap on the pointed side and no gap on the flat side when the clamp is correctly tightened. 3. Route tach’s wire harness lead under dash for simplest and cleanest installation. 4. Make your wire connections as follows: a. Locate the pink wire under the speedo (sometimes has a plastic bullet end on it). Cut the plastic off and splice the pink wire with the green wire from the tachometer. b. Find the orange wire and attach the tach power wires to it (usually blue & red from tach (incandescent) or red & yellow for single color LED tachs. On 7-color LED models it is red from tach and red from LED controller box) . c. Locate a suitable ground (usually a bare frame bolt) and attach the black wires from the tachometer and the LED controller box (if equipped).

Incoming search terms:

URAL TOURIST / SPORTS Repair Manual

0

Filed Under (Ural) by admin on 18-11-2010

download
Maximum speed of motorcycle 108 km/h / 65 mph *119km/h / 74 mph 122 km/h / 77 mph Reference fuel consumption at 85% of maximum speed 12.5 km/l / 29 mpg 14 km/l / 32.5 mpg 16.7 km/l / 39 mpg Dry mass of motorcycle 700 lb. / *680 lb. 460 lb. Maximum load-carrying capacity 500 lb/485 lb/*400 lb 330 lb. Noise level below 80db OVERALL DIMENSIONS OF MOTORCYCLE Length 2500 mm / 8 ft 2200 mm / 7 ft Width 1700 mm / 5 ft 6 in 850 mm / 2 ft 8 in Height 1100 mm / 3 ft 6 in 1060 mm / 3 ft 8 in Road Clearance 125 mm / 5 in Seat height 840 mm / 33 in 810 mm / 32 in Wheel base 1470 mm / 55 in ENGINE Type 4 stroke, overhead valves, opposed twin-cylinder Displacement 649 cc Cylinder bore 78 mm / 3.07 in Piston stroke 68 mm / 2.68 in Compression ratio 8.5 Rated horsepower 35 Rated rotational speed 5600 RPM Rated torque, Nm 45 Nm / 398.7 in-pound Ignition system Contactless with electronic ignition timing Lubrication system Dual system of forced lubrication and by splashing Lubricant SAE 20W/50 (see Owner’s Manual Maintenance Section) CARBURETOR Carburetor type Keihin Seiki 32 CVK Number of carburetors 2 Air cleaner Pleated Paper Filter Fuel 91 octane premium unleaded gasoline PCV Valve Internal Breather ELECTRICAL EQUIPMENT Ignition system 12 V Ignition coil B204 Spark plugs NGK BP7HS or NDW20FP-1 Ignition timing Automatic spark timer Power supplies Alternator Storage battery (Russian supplied with new motorcycle) Recommended replacement: Interstate #12N9-4B-1 Voltage regulator (electronic) Internal to Alternator Horn C205B Headlight URAL  part no. UA-TB6014-017 Sylvania Incandescent 6014, 7″ round sealed beam TRANSMISSION Clutch Dry double-disk clutch Gearbox 4 speed box with reverse gear (no reverse for solo model) and gear shifting foot pedal GEAR RATIOS TOURIST / SPORTSMAN / UTILITY SOLO/CRUISER I gear 3.6 3.6 II gear 2.28 2.28 III gear 1.7 1.7 IV gear 1.3 1.3 Reverse gear 4.2 N/A on Solo 4.2 on -10 mdls Speedometer drive ratio 0.4 0.5 Final drive Pair of bevel gears with propeller shaft Final drive ratio 4.62 3.89 FLUID CAPACITIES TOURIST & -10 Models Sportsman Solo Gasoline tank 19 L / 5 Gal 19L / 5 Gal 18.5 L / 4.9 Gal Reserve 2L / 0.5 gal 2L / 0.5 gal 2L- / 0.5 Gal Engine crankcase 2 L / 2 qt. + 3.6 oz. 2.0L / 2.11 qt 2 L / 2 qt. + 3.6 oz. Gearbox 0.9L / 1 qt 0.9L / 1 qt 0.9L / 1 qt Final drive 110 ml / 3.85 oz. 150 ml / 5.25 oz. 110 ml / 3.85 oz. Telescopic Forks (-10 & solo models) N/A on Tourist N/A on Sportsman 135 ml / 4.56 oz. Shock Absorbers 105 ml / 3.55 105 ml / 3.55 oz 105 ml / 3.55 oz

2002 URAL Classic Motorcycles BC-75 (Bavarian Classic) LC-75 (Luxury Cruiser) Tourist, Adirondac & Patro Owner's Manual

0

Filed Under (Ural) by admin on 02-11-2010

download
Front brake control lever (Fig.1, #5). When the lever is squeezed, the front wheel brake is actuated. The front brake should be used together with rear brake. When the brake lever is squeezed, the stop signal lamps are switched on. Kick lever (Fig.1, #11) is designed to start the engine. On pressing the lever the crankshaft of the engine is actuated through the gearbox. The lever is returned to its initial position by the spring inside the gearbox. Note: this is a backup to the electric starter. Gear shift foot pedal (Fig.1, #12) is a two-arm type. When the front arm is pressed, shifting from high to lower gears takes place. When the rear arm is pressed, shifting from low to higher gears takes place. Since the heel-toe shift lever is short-coupled, you will find it easier to shift up if you rotate the heel of your left foot in towards the rear arm before stepping on it with your heel. The neutral position is fixed between the I and II gears. Speedometer is on the dash board, with trip (Note..BC-75 has no trip odometer) and total odometer. The trip odometer is reset to zero by rotating push-button (Fig.1, # 3) counterclockwise. Note that the odometer reads in kilometers not miles. Ignition Switch (Fig.1, # 19) has three fixed positions of the key. The position and switching diagram of the ignition locks are shown above.
18 The indicator lamps are mounted on the instrument board: (Fig. 1, # 2) — turn indicator pilot lamp, (orange) (Fig. 1, # 4) — gearbox neutral and reverse gear engagement, (green) (Fig. 1, # 18) — head lamp high beam indicator, (dark blue) (Fig. 1, # 20) — alternator fault indicator lamp, (red) Note: If the red alternator fault light stays on continuously during normal operation above approximately 1500 RPM, there is a problem with the charging system or battery. Throttle Control (Fig.1, # 6) is on the right handlebar. Turning the twist grip counterclockwise increases engine speed. Ignition Cutoff Switch (Fig.1, # 7) has two positions, ignition off (up), and ignition on (down). Low and High Beam Light Switch (Fig.1, # 15), turn indicator switch (Fig.1, #13) and horn push-button (Fig.1, # 14) are combined in one unit on the left-hand handle bar control housing. Master Battery Switch (Fig.1, # 21) is under the seat. Electric Start Button (Fig. 1, # 8) is located on the right-hand twist grip, below the kill switch. The Steering Damper absorbs lateral kicks on the front wheel. Turning tightening bolt (Fig.1, # 17) clockwise increases friction. This can be used while riding over bad roads

Incoming search terms: