1994-2002 DUCATI 916/ 995/ 996/ 998/ 748 NTEGRATED TAIL KIT CUSTOM LED INSTALLATION INSTRUCTIONS

0

Filed Under (Ducati) by admin on 25-10-2010

download
REMOVE THE LENS FROM THE STOCK TAIL LIGHT. 2 ) REMOVE THE BOTTOM COVER FROM THE STOCK TAIL LIGHT 3 ) REMOVE THE LAMP ASSEMBLY BY PUSHING IT TOWARDS THE LENS SIDE OF THE HOUSING AS SHOWN. THE LAMP ASSEMBLY IS FRICTION-FITTED INTO THE HOUSING AT 4 POINTS. IT MAY BE NECESSARY TO WORK AT THESE POINTS INDIVIDUALLY TO FREE UP THE ASSEMBLY. 4 ) SNIP OFF THE THREE WIRES THAT CONNECT TO THE LAMP ASSEMBLY. CUT THE WIRES AS CLOSE TO THE LAMP ASSEMBLY AS POSSIBLE. 3 4 ) RUN THE PROVIDED ½” SCREWS THROUGH FROM THE FRONT SIDE OF THE CUSTOM LED BOARD AND SECURE WITH THE NYLON (PLASTIC) NUTS ON THE BACK SIDE OF THE CUSTOM LED BOARD. GENTLY TIGHTEN THE NYLON NUTS BY HOLDING THEM WITH YOUR FINGERS AND TURNING THE SCREW ( DO NOT OVER TIGHTEN !!!). 6 ) PLACE THE PROVIDED MOUNTING ANGLE OVER THE PROTRUDING SCREWS (AND NYLON NUTS) AS SHOWN. 7 ) INSTALL THE PROVIDED WASHERS AS SHOWN. 8 ) INSTALL THE PROVIDED NUTS AND CAREFULLY TIGHTEN WITH PLIERS ( DO NOT OVER TIGHTEN !!!)