Kawasaki Mule Duster Adhesive Hook Strip Installation Instructions

0

Filed Under (Kawasaki) by admin on 30-04-2012

download
Use the loop on the Duster as a guide to locate the Hook Strip on the front of the bed. Clean the area and install the Adhesive Hook Strip as in Step 1. Install Adhesive Hook Strip to Front of Bed Cut the Adhesive Hook Strip into six (6) pieces to match the loop sewn to the Duster. Use the loop on the Duster as a guide to locate the Hook Strip on the sides of the bed and the tailgate. Clean the areas with a 50% Water/Alcohol Solution. Peel the backing off the hook a little at a time and press it fi rmly into place. Install Adhesive Hook Strip Allow 72 hours for the adhesive to set. Avoid unnecessary fastening and unfastening of the Duster during this period. Open Bed Open the bed of the vehicle. Tailgate Adhesive Hook Strip Allow 72 hours for the adhesive to set. Avoid unnecessary fastening and unfastening of the Duster during this period. Secure Duster to Front of Bed Fasten the loop sewn to the front of the Duster to the Adhesive Hook Strip on the front of the bed

2010 RIDGELINE MOTORCYCLE BED EXTENDER INSTALLATION AND REMOVAL

0

Filed Under (Honda) by admin on 26-11-2011

download
Using an awl, pierce through the seals in the holes on the left side bed lining Install the left latch to the left side bed lining with three hex bolts While wearing eye protection, drill a 3 mm hole at the mark on the left side of the tailgate. Widen the hole with a 8 mm drill bit. To prevent damage to the inner vehicle parts, wrap a tape around the drill bit tip to the root in the measurement as shown. Remove any burrs Align the non-threaded wedge with the threaded wedge at three joints between the left and center tubes, then secure the wedges with one T-20 torx screw each.