Honda ATV 650 Lift Kit REMOVAL AND Installation

0

Filed Under (Honda) by admin on 14-01-2012

download
Place jack under center on the ATV front end and lift until front wheels clear the ground. Be careful to support ATV properly so that it is secure, but so that the A-arms and shocks can droop to full extension. 2. Remove front wheels and shocks. 3. Using a shock spring compressor, compress the spring on the shock and remove the spring retaining ring.
CAUTION: The spring is installed under tension. Failure to use a shock spring compressor could cause loss of control of the spring, which could unload rapidly causing bodily injury. If you do not have a shock spring compressor you should acquire one or take it to a dealer or professional mechanic for installation of the stiffeners. 4. Remove the spring. 5. Insert the smaller front spring stiffener onto the shock with the lip of the spring stop, on the shock, mating into the recessed portion of the spring stiffener. 6. Slide the spring back onto the shock and it should rest on the lip of the spring stiffener.
7. Reattach the spring retaining ring. 8. Repeat steps for the opposite side. Once springs are complete reattach the top of the shock to the top shock mount on the ATV and the spring stiffener will be closest to the A-arm. 9. Take two of the ā€œLā€ brackets and connect them to the bottom of the shock, the part that connects to the A-arms. 10. There is a top and bottom to the ā€œLā€ bracket. See the diagram

Incoming search terms:

Kawasaki Vulcan 1600 Classic Exhaust Installation Instructions

0

Filed Under (Kawasaki) by admin on 25-10-2010

download
1. Loosen both top and bottom muffler hose clamps as shown. Remove 10mm bolt with 10mm nut on back side of bracket as shown. 3. Loosen 6mm bolt on passenger foot peg bracket as shown. Once loose remove top muffler 10mm nut and 10mm bolt. Slide bolt out of rubber grommet. . Carefully remove top and bottom stock mufflers, by sliding both mufflers out by rear fender. ( Use Phillips screw driver and remove bolt as shown. Remove side cover carefully by pulling towards your body.figure Figure 9 6. Remove rear head pipe by removing two stock socket cap nuts as shown. Once nuts are removed pull rear head pipe away from bike and set aside. (Fig.10)

Kawasaki Vulcan 1600 Classic Exhaust Serrated Installation Instructions

0

Filed Under (Kawasaki) by admin on 25-10-2010

download
Loosen both top and bottom muffler hose clamps as shown. (Fig.1&2) Figure 1 Figure 2 2. Remove 10mm bolt with 10mm nut on back side of bracket as shown. (Fig. 3&4) Figure 3 Figure 4 3. Loosen 6mm bolt on passenger foot peg bracket as shown. Once loose remove top muffler 10mm nut and 10mm bolt. Slide bolt out of rubber grommet. (Fig.5&6) Figure 5 Figure 4. Carefully remove top and bottom stock mufflers, by sliding both mufflers out by rear fender. (Fig. 7) Figure 7 5. Use Phillips screw driver and remove bolt as shown. Remove side cover carefully by pulling towards your body. (Fig.8&9) Figure 8 Figure 9 6. Remove rear head pipe by removing two stock socket cap nuts as shown. Once nuts are removed pull rear head pipe away from bike and set aside. (Fig.10) Figure 107. Remove stock front head pipe by removing two stock socket cap nuts as shown. Once nuts are removed pull front head pipe away from the bike and set aside. (Fig.11&12) Figure 11 Figure 12

Incoming search terms: