Toyota Camry, Celica, Corolla, MR2 (1995), Paseo, Pickup (1995), RAV4 (1996), Supra, Tacoma, Tercel, T100, 4Runner TRANSMISSION REMOVAL & INSTALLATION – M/ T

0

Filed Under (Toyota Manuals) by admin on 22-06-2011

Download
Disconnect negative battery cable. On 2.2L (5S-FE) models,
remove battery and cruise control actuator. On all models, remove air
cleaner case with air intake hose. Remove clutch release cylinder with
hose attached and secure aside.
2) Remove starter. Disconnect necessary ground straps,
electrical connections and control cables from transaxle. Remove upper
transaxle mounting bolts from cylinder block.
3) Raise and support vehicle. Remove front wheels. Remove
lower engine covers. Drain transaxle fluid. Remove axle shafts from
transaxle. See AXLE SHAFTS article in AXLE SHAFTS & TRANSFER CASES
section

Incoming search terms:

Toyota Camry TRANSMISSION REMOVAL & INSTALLATION – M/ T

0

Filed Under (Toyota Manuals) by admin on 21-06-2011

Download
1) Disconnect negative battery cable. Remove air cleaner case
with air intake hose. Remove cruise control actuator. Remove clutch
release cylinder with hose attached and secure aside.
2) Remove starter. Disconnect necessary ground straps,
electrical connections and control cables from transaxle. Remove upper
transaxle mounting bolts from cylinder block.
3) Raise and support vehicle. Remove front wheels. Remove
lower engine covers. Drain transaxle fluid. Remove axle shafts from
transaxle. See appropriate AXLE SHAFTS article in AXLE SHAFTS &
TRANSFER CASES section. Remove stabilizer bar mount and bushing from
crossmember

1998 Toyota Camry LE Sedan L4-2164cc 2.2L DOHC MFI REMOVAL

0

Filed Under (Toyota Manuals) by admin on 21-06-2011

Download
Remove the 2 bolts holding the support stay to the support bracket.
b. Remove the 2 bolts holding the support bracket to the front frame.
c. Remove the 2 bolts and 2 nuts holding the front exhaust pipe to the
center exhaust pipe.
d. Remove the 3 nuts holding the front exhaust pipe to the exhaust manifold.
e. Remove the front exhaust pipe and 2 gaskets

Remote Starter Integration for the 2007 Toyota Camry equipped with the Smart Key System with Push Button Start

0

Filed Under (Toyota Manuals) by admin on 15-06-2011

Download
Most of the connections will be done behind the Fuse box. This fuse box is located under the driver side underdash. Also, the vehicle’s TACH wire can be found inside vehicle, as per diagram below and it
is suggested to use this wire for the remote start tach source. The remote start hood pin
switch wire is the only wire which must be run into the engine compartment for safety

Toyota Camry Repair Manual 1983-1991

0

Filed Under (Toyota Manuals) by admin on 15-06-2011

Table of Contents
* Introduction: Vehicle identification numbers; Buying parts; Maintenance techniques, and more.
* Tune-up and routine maintenance
* Engine and overhaul procedures
* Cooling, heating and air-conditioning systems
* Fuel and exhaust systems
* Engine electrical systems
* Emissions control systems
* Transmission
* Brakes
* Suspension and steering systems
* Body
* Chassis electrical system
* Wiring diagrams

1997-2001 Toyota Camry, Avalon, Solara, Lexus ES300 Repair & Service Manual

0

Filed Under (Toyota Manuals) by admin on 13-06-2011

Introduction: Vehicle identification numbers; Buying parts; Maintenance techniques, and more.
* Tune-up and routine maintenance
* Four-cylinder engine
* V6 engine
* Engine and overhaul procedures
* Cooling, heating and air-conditioning systems

Toyota Camry 2006 clean engine

0

Filed Under (Toyota Manuals) by admin on 01-06-2011

Download
Why clean the throttle body on your Toyota? The Toyota 4 cylinder engine is one of the best in the world, but it has one weak spot. The design of the P.C.V. system is such that blow-by gases get into the throttle body and butterfly area. Over time, after 30,000 miles or more, the build-up of crud caused by this can cause your engine to run wrong. Many people wind up taking their car to the shop and spending lots of money to fix a rough-running, hard-starting engine when all they need is some rags, a screwdriver, and $5 for a can of throttle body cleaner (or a little more for a can of Seafoam) and 20 minutes worth of time to clean inside their throttle body. This article tells you how

Toyota Camry, 1992-1996 Avalon Repair & Service Manual

0

Filed Under (Toyota Manuals) by admin on 25-05-2011

epair manual covers all Toyota Camry 1992-1996, and Toyota Avalon models, 1995-1996.

Table of Contents

* Introduction: Vehicle identification numbers. Buying parts. Safety. Maintenance techniques. Chemical and lubricants, and more.
* Tune-up and routine maintenance
* Four-cylinder engine
* V6 engines
* General engine overhaul procedures
* Cooling, heating and air-conditioning systems
* Fuel and exhaust systems
* Engine electrical systems
* Emissions control systems
* Transmission

Incoming search terms:

Toyota Camry L4 – 2.4L 2004 Brakes and Traction Control Disc Brake System Service and Repair

0

Filed Under (Toyota Manuals) by admin on 24-05-2011

Download
REMOVE FRONT DISC BRAKE CYLINDER SLIDE BUSH 10. Remove the cylinder slide bush from the cylinder slide pin.
a. REMOVE FRONT DISC BRAKE BUSH DUST BOOT 11. Remove the 2 bush dust boots from the disc brake cylinder mounting. a. REMOVE FRONT DISC BRAKE CYLINDER MOUNTING LH 12. Remove the 2 bolts and disc brake cylinder mounting LH. a. REMOVE CYLINDER BOOT 13. Using a screwdriver, remove the set ring and cylinder boot.
a. REMOVE FRONT DISC BRAKE PISTON 14. Place a piece of cloth or similar, between the piston and the disc brake cylinder. a. Use compressed air to remove the piston from the disc brake cylinder. CAUTION: Do not place
your fingers in front of the piston when using compressed air. NOTICE: Do not spatter the brake fluid

All 2002 – 2007 Toyota & 2004 – 2007 Scion Models REPAIR MANUAL SUPPLEMENT VEHICLE PULLING TO ONE SIDE

0

Filed Under (Toyota Manuals) by admin on 23-05-2011

Download
Relationship Between Tire Characteristics and Vehicle Pulling to One Side When radial tires are rotating, they have the characteristic of generating force in the lateral direction between the tire and the road surface. This lateral force is comprised of two factors: S Ply-steer, which changes direction according to the rotation direction of the tires.
S Conicity, which is generated in a fixed direction regardless of the tire rotation direction. If these lateral forces are too strong, vehicle pulling will occur. A. Ply-Steer Lateral force due to ply-steer is produced by the construction of the belts inside the tire tread. With radial tires, the wire of the belt is slanted as shown in the illustration below. Thus, it is in the lateral direction that tire tread easily changes shape (stretches), and lateral force is generated between the tire and the road surface in the lateral direction.

Incoming search terms:

Incoming search terms: