Motorcycle Security System INSTALLATION MANUAL


Filed Under (Tips and Review) by admin on 04-04-2012

The transceiver is pre-charged at the factory and will operate out of the box but we recommend that it be charge for at least 10 hours when first operated to insure full life of battery. 1. Plug in provided charger into the transceiver. 2. While the transceiver is charging the red status LED will flash twice every two seconds. 3. When transceiver is fully charged no LED will flash. 4. Recharge the transceiver every day to maintain full function. Receiver Status LED Panel The status LED panel provides information about the status of the receiver, memory and the battery level. Receiver on / Memory Trigger Blue LED will flash Receiver on / Low Battery Red LED will flash. Receiver On White LED will flash Range LED Range LED indicates when the transceiver is still with in receiving range of the system. In Range Green LED will flash Out Of range Red LED will flash Operating the transceiver The following instruction assumes that the transceiver is with in range of the motorcycle. Arming Press the #1 button, the siren will chirp 3 times. The transceiver will chirp twice and the white status LED will continuously flash to confirm that the receiver is on. The range LED light will then flash green . System is armed.

TOYOTA/ LEXUS Transponder Bypass TYPE 1 & 2 INSTALLS


Filed Under (Toyota Manuals) by admin on 16-09-2011

The 1100X/F-TL interface module is used when installing remote start
products in Toyota/Lexus vehicles equipped with a factory immobilizer.
The 1100X/F-TL allows for easy interfacing between the remote start and
the factory immobilizer, while maintaining the integrity of the OEM sys-
tem. The factory transponder-based anti-theft system uses a small elec-
tronic chip hidden in the key to send a code to the vehicle’s transceiver
when the ignition is energized. The key must be placed in the ignition
and turned to the RUN position. This energizes a coil surrounding the
key, which in turn energizes the chip, which sends a code to the vehicle. If
the vehicle does not detect the code being sent, the vehicle will start and
then immediately shut off or will just crank, and the anti-theft light will
flash. The 1100X/F-TL provides a valid code to the vehicle whenever it is
remote started, but does not affect the immobilizer system during normal
vehicle operation; the immobilizer system remains fully functional