TOYOTA TACOMA 2005 D RING CARGO TIE DOWN Procedure

0

Filed Under (Toyota Manuals) by admin on 14-10-2011

download
Care must be taken when installing this accessory to ensure damage does not occur to the vehicle. The installation of this accessory should follow approved guidelines to ensure a quality installation. These guidelines can be found in the “Accessory Installation Practices” document. This document covers such items as:- — Vehicle Protection (use of covers and blankets, cleaning chemicals, etc.). — Safety (eye protection, rechecking torque procedure, etc.). — Vehicle Disassembly/Reassembly (panel removal, part storage, etc.). — Electrical Component Disassembly/Reassembly (battery disconnection, connector removal, etc.). Please see your Toyota dealer for a copy of this document. 1. Hole Placement – Left Side (a) Measure vertically 70 mm up from bottom of truck bed, using marking pencil draw a small horizontal line. (Fig. 1-1) (b) Horizontally measure 72 mm from the front of truck bed, using marking pencil draw a vertical line. (Fig. 1-1) (c) Set drill stop at 1″ from drill tip. (d) Use a center punch to mark the intersection of the two lines and drill a 7/16″ hole as shown in Fig. 1-1. NOTE: Illustration is for long bed, D-cab short bed uses the same process. 2. D-ring Assembly Preparation Left Side (a) Insert the D-ring Assembly into the previously drilled hole. (b) Hold the D-ring Assembly in place by using a strip of duct tape.

HARLEY DAVIDSON FLTR DETACHABLE TOUR-PAK ANTENNA RELOCATION KIT

0

Filed Under (Harley Davidson) by admin on 19-02-2011

download
Drilling Instructions for Antenna Base Mounting and Cable Routing 1. See Figure 1. Measure and determine the center of the outside rear Tour-Pak wall. 2. Lay a strip of 2 inch wide masking tape from top to bottom over the approximate center. 3. Very carefully measure again and mark the center near the top of the tape strip. Measure and mark the center near the bottom of the strip. 4. Draw a line from the top mark to the bottom mark. 5. Facing the centerline you have drawn, measure 9-1/4 inches from the center line to the left side. 6. At the 9-1/4 inch dimension, lay a vertical strip of 2 inch masking tape from the top to approximately the middle of the Tour-Pak wall. 7. Very carefully measure again and mark 9-1/4 inches from the top of center line to the top of the tape strip. Measure and mark 9-1/4 inches from the bottom of the center line to the bottom of the strip. 8. Draw a vertical line from the top mark to the bottom mark. 9. Measure 1-1/4 inches from the top edge, down the vertical line you have drawn and draw a short horizontal line across the vertical line. 10. Measure 1-1/2 inches down the vertical line you have drawn from your FIRST short horizontal line and draw another short horizontal line across the vertical line