Kawasaki Ninja 650R (ER-6F) & ER-6N Resource Upgrading the Suspension on the Kawasaki ER6-F/ N

0

Filed Under (Kawasaki) by admin on 30-11-2010

download
Top fork is as removed. Kawasaki Ninja 650R (ER-6F) & ER-6N Resource Before removing the fork from the clamps on the yokes I loosened the fork top. Before removing the fork top the fork-slider was placed in a vice and the bottom bolt loosened….. … before finally being removed with the fork upside down. Because the springs were still in situ this gave sufficient tension on the damper-rod to prevent it from turning and allow the bolt to be removed. When I turned the fork the right-way up to remove the fork-top I did it over a container to catch the oil. Kawasaki Ninja 650R (ER-6F) & ER-6N Resource All the OE components that will no longer be required. Left to right. Fork-top, spacer tube, washer, spring, damper-rod. Bottom bolts get re-used. Old and new, laid-out for comparison. The damper unit, minus spring and fork-top, drops inside the stanchion and slider. Kawasaki Ninja 650R (ER-6F) & ER-6N Resource Then the bolt goes back in, as tight as possible, to secure it. Top fork is done, second one awaits. Note the spring seat on the right, just below the spring. This drops over the damping rod after the oil has been added. The small locking-nut screws over the threaded part of the damping-rod next, all the way to the bottom. Spring drops in and then the fork-top screws on to the damping-rod as well, all the way down to the lock-nut which is used to secure it. At this point the stanchion is extended to the fork-top which is screwed in. Job done.

Incoming search terms:

DUCATI MONSTER OGGY KNOBB KIT installation Instructions

0

Filed Under (Ducati) by admin on 26-10-2010

download
Congratulations on purchasing your Oggy Knobb kit. It has been designed to reduce damage to your motorcycle from impact and abrasion by the road surface in an accident. We have used only the highest quality materials to achieve the strength and appearance your investment deserves. Carefully read the fitting instructions below and check you kit contents before starting installation. If you are unsure or not confident about installing Oggy Knobbs yourself, see your mechanic. Note-Does not fit pre August 1998 600 & 750 or Montsers using 12mm engine mounting bolt. Instructions: 1. Remove the blanking plugs and engine mounting bolt which passes through the frame and crankcases. The position of this bolt can be seen from the photo above. 2. Fit the supplied threaded rod in place of the original bolt with an even amount projecting from each side. 3. Fit the aluminium spacer on each side making sure the smaller diameter seats inside the recess in the frame. 4. Fit the Oggy Knobb, flat washer, spring washer and nut on each side. 5. Tighten the two nuts firmly against each other making sure that an even amount of thread is exposed on each side once done. The use of a thread locking agent is recommended. Check tightness of the nuts regularly.

Incoming search terms: