Honda CBR 600 F4i 2004 – 2005 Bestem USA Fiberglass F13 Installation Guide

0

Filed Under (Honda) by admin on 20-11-2011

download
We highly recommend having a professional install this undertail. A dremel tool or nsimilar is what we found the best to cut plastics. Place bike on a rear wheel center stand. Remove passenger seat and hardware which secure stock undertail section Unplug the harness that connects tail light and remove the stock undertail. Position Bestem undertail close to the bike and determine the amount of plastic needs to be cut out. Use a dremel tool to carefully trim off plastics (glove boxes etc). This is the most time consuming part of the installation but your patience will be paid off. 5) Once the new undertail is slide in, determine holes need to be drilled (only on
certain models). Reuse the hardware for the stock undertail to secure the new undertail. 6) The wiring color codes from two round tail lights are Black Wire – Ground, connects to Ground wire. Red Wire – Brake Light, connects to brake light. Blue Wire – Running Light, connect directly to the running light. Orange Wire – Turn Signal, connect them to your L/R turn signal wires We highly suggest you solder the connections and use heat shrink wrap to seal the connections. Test your lights before going out for a ride, also make sure your new undertail is securely installed on the bike. Now it’s time to go out for a spin!

STEERING GEAR/ STEERING WHEEL REMOVAL AND INSTALLATION

0

Filed Under (Uncategorized) by admin on 05-10-2011

download
TEERING GEAR/STEERING WHEEL REMOVAL & INSTALLATION Page 3 of 4 STEERING GEAR/STEERING WHEEL INSTALLATION PROCEDURES (Cont’d) 2. Center spiral cable. a. Turn the cable counterclockwise by hand until it becomes harder to turn. b. Then rotate the cable clockwise about 2.5 or 3 turns to align the marks. (See Fig. 4) 3. Install the steering wheel. a. Align the matchmarks on the wheel and steering main shaft. b. Temporarily tighten the wheel set nut. c. Connect the spiral cable connector. 4. Bleed Power Steering System (when applicable). 5. Check steering wheel center point. 6. Torque steering wheel set nut. See the applicable vehicle’s repair manual for the torque specification. 7. Install and center steering wheel pad. NOTICE: Make sure the pad is centered and installed to the specified torque. If the pad has been dropped, or there are cracks, dents or other defects in the case or connector, replace the wheel pad with a new one. When installing the pad, take care that the wiring does not interfere with other parts and is not pinched between other parts. a) Connect the airbag wiring connector. b) Install the pad after confirming that torx screws are in the screw case. c) Using a torx socket, torque the screws to the specification in the vehicle’s Repair Manual. (See Fig. 5) d) Install the steering wheel lower cover

Incoming search terms: