AVALON WINDSHIELD MOLDING WIND NOISE REPAIR

0

Filed Under (Toyota Manuals) by admin on 01-11-2011

download
TOYOTA MOTOR SALES U.S.A., INC. TMM has implemented a production process change to improve windshield sealing. EFFECTIVE DATE VIN REFERENCE 4/26/95 4T1GB11E5SU038470 To eliminate whistling noise from the windshield top outside molding, fill in the windshield channel with a urethane sealant such as 3M Window Weld Re-sealant or equivalent (refer to illustration below for proper application)

2007 4Runner ROOF RACK CROSS BAR INSTALLATION AND REPAIR

0

Filed Under (Toyota Manuals) by admin on 30-10-2011

download
facing forward. NOTE: The cross bars will create wind noise at highway speeds if they are installed backwards. 3. Align the ends of the front and rear cross bars with the paint marks on the roof rack as illustrated. Then securely tighten the knobs. NOTE: Installation positions of cross bars shown above are most effective to reduce wind noise. 4. Install the right and left rear roof rack leg covers. A. Insert the protrusion at the front of the cover into the roof rack rail. B. Place the cover on the leg, aligning each rear end. At this time, do NOT press the cover down. C. Engage the cover claws located towards the outside of the vehicle. D. Engage the cover claws located towards the inside of the vehicle. NOTE: If the inside and outside cover claws are pressed down at the same time, the cover claws may be damaged. E. Check that the cover is installed securel

2003 – 2005 Matrix WIND NOISE FROM DOOR GLASS WINDOW RUN REPAIR

0

Filed Under (Toyota Manuals) by admin on 28-10-2011

download
NOTE: Use the same procedure for the LH side as the RH side. 1. Place the window in the down position. 2. Remove the window run. Completely remove the double-sided tape remaining on the frame. 3. Thoroughly clean the door frame using a white body shop towel and Kent Acrysol. NOTE: Do NOT use red shop towels. These towels contain silicone. 4. Install the door glass window run. A. Position the glass run at the No. 2 and No. 3 corners of the door frame and then attach the middle part of the run. B. Insert the glass run into the window run channels. NOTE: Do NOT apply water or lubricant to the glass run when inserting it into the door. Make sure the glass run fits securely into the holes of the door frame

Incoming search terms: