SUZUKI PKT-045 V-STROM LEFT FRONT PANEL Installation Manual

0

Filed Under (Suzuki) by admin on 19-02-2012

download
STEP #1 – Remove the seat & the left side fairings. See the Suzuki service manual. STEP #2 – Drill a 18mm hole into the panel (11/16″ hole saw recommended and is available on our site) where shown [A]. If the hole is too small for the socket open it with emery cloth or a file. Watch the clearance behind the panel; make sure the socket has room. Attach the socket to the panel; use a dab of Silicone on the socket and jam nut. Important: Do NOT use Loctite or over-tighten. STEP #3 – Install the cable starting at the battery through to the front of the bike. Route the cable under the bracket [B]. You’ll find it a bit tight to get through between the frame and motor [C]. Ty-wrap the cable to the frame. Run the cable up to the front fairing. Slip the fuse-holder in the location shown [D]. Disconnect the black and red battery terminals. Connect the ground wire to the bolt [E]. You can cut a notch in the ref boot [F]. Connect the red wire to the battery posts as follows: RED WIRE = BATTERY POSITIVE STEP #4 – Reconnect the positive & negative battery terminals. Install the fuse in the fuse-holder. The center terminal is plus and the outer ring is negative (see dwg below). Apply either dielectric grease or Vaseline to terminals. Connect the red wire to the POSITIVE terminal and the black wire to the NEGATIVE terminal. Use a voltmeter to check if the polarity is correct. STEP #5 – Apply the remaining ty-wrap to the wiring harness where needed. Do NOT allow the harness to directly contact the motor or exhaust.

1991-1998 DUCATI 750ss 900ss POWERLET Installation Instructions

0

Filed Under (Ducati) by admin on 25-10-2010

download
STEP #1 Remove tail fairing & seat. STEP #2 Route wires starting at the battery and finishing at the bracket. STEP #3 Attach the wires to the socket and test. STEP #4 Mount the bracket. STEP #5 Look over your work. STEP #6 Put everything you took off back on. Detailed Instruction: STEP #1 – Remove the tail fairing, & seat. See the Ducati service manual. STEP #2 – Stretch out the wiring harness. Locate a wiring harness behind the frame rail[B]. Grab the socket end of the harness and start routing the harness by looping the wires up through the gap between the frame members just behind the battery[B]. You should be following the wiring harness behind the frame rail. The wires will exit in the underside of the seat area, just like the existing harness[D]. Attach the ground (black) wire under the hinge mounting bolt[C]. Tie wrap the harness under the cross member[E]. Go back to the battery area and install the fuse in the fuse holder than, tuck the fuse holder under the rubber strap in front of the plus terminal of the battery[F]. Slip the red wire under the red battery boot[F]. Connect the red wire to the battery posts as follows: RED WIRE = BATTERY POSITIVE STEP #4 -Attach the wires to the socket. The center terminal is plus and the outer ring is negative (see dwg below). Apply either dielectric grease or Vaseline to the terminals. Use a voltmeter to check if the polarity is correct