EVO 3-Phase Charging System Installation And Owner's Manual

0

Filed Under (Tips and Review) by admin on 19-11-2010

download
install rotor onto sprocket shaft and seat against rotor spacer 9. Install the compensator extension shaft on the sprocket shaft 10. Using your motorcycle’s specific repair manual instructions, check for proper chain alignment. Use OEM-specified shims to bring chain alignment into specification if required. 11. Using your motorcycle’s specific repair manual instructions, install the primary drive and clutch. Assure that all driveline components line up correctly. 12. Apply Loctite Threadlocker #262 (“red”) to the threads of the sprocket nut (also supplied with compensator shaft extension kit). Tighten sprocket nut to 150-165 ft-lbs (203.4-223.7 Nm). 13. Using your motorcycle’s specific repair manual instructions, install the primary cover. 14. Connect the negative battery cable. 2.3 Factory Regulator Removal 1. Disconnect the negative battery cable. 2. Using your motorcycle’s specific repair manual instructions, remove the regulator. Save the factory-supplied hardware. 2.4 3-Phase Regulator Installation 1. Connect the 3-pin stator connector to the regulator. 2. Using the factory-supplied hardware, locate the 3-phase regulator on the mounting bracket and install using the factory-supplied hardware. Tighten to 50-80 in-lbs. 3. Attach the ground wire between the bracket mounting bolt and the bracket. Tighten to 70-100 in-lbs. 4. Trial-fit the long power wire to the motorcycle, and route to the original location of the factory regulator wire on the circuit breaker. 5. Trim any excess wire, and strip 5/16″ of insulation from the end of the wire using a wire stripper. 6. Slip the 1″ length of heat shrink (supplied) onto the wire. 7. Crimp on the (supplied) ring lug to the end of the wire, taking care that a good crimp connection is made.

Comments are closed.