Filed Under (Tips and Review) by admin on 17-02-2012

A. Open or remove the seat according to the service-manual instructions. !!! Warning !!! Warning To protect against shock and accidental start-up of the vehicle, disconnect the battery cables, negative cable first, before proceeding. Inadequate safety precautions could result in death or serious injury. !!! Warning !!! Warning Always disconnect the negative battery cable first. If the positive battery cable should contact ground with the negative cable installed, the resulting sparks may cause a battery explosion which could result in death or serious injury. B. Disconnect the battery, negative cable first, according to the service-manual instructions. There are two options for installing the Heat Demons. Option A is doing the installation without removing the handlebar and Option B includes the removal of the handlebar. Two holes need to be drilled in the handlebar and the Option chosen depends on how comfortable the installer is on drilling holes in the bar. One advantage for removing the handlebar is the Right Handlebar Control can be left intact during the installation. The disadvantage is on some models the headlight and trim pieces need to also be removed along with the cables that are attached to the handlebar. Option A – Installation without removing the handlebar. The 4 level Controller can be mounted on the left or right side of the handlebar so choose the side and location that will provide the easiest installation and most convenient operation. The width between the holes will allow the Controller to be mounted directly to the clutch bracket or brake reservoir on many Yamaha, Honda, Kawasaki, Suzuki or Triumph motorcycles. On other motorcycles the back side clamp and cap screws are provided to mount the Controller to the handlebar

Write a comment