DIAGNOSTIC TESTER CONTROLLER AREA NETWORK (CAN) INTERFACE MODULE

0

Filed Under (Toyota Manuals) by admin on 30-10-2011

download
Remove the original DLC3 Cable and store it in the Diagnostic Tester storage case. 2. Connect the CAN Interface Module to the DLC Cable. 3. Use the Diagnostic Tester with the CAN Module installed for all DLC3/J1962 based vehicle communication. 4. If you experience problems with the Diagnostic Tester or CAN Interface Module, please contact Toyota Special Service Tool Customer Support at 1-800-933-8335. NOTE: There is no need to remove the CAN Interface Module when working with non-CAN systems or older software versions (Version 10.1a or earlier). The Diagnostic Tester will communicate with all DLC3/J1962 based systems with the CAN Interface Module installed. For DLC1 and DLC2 communication you must continue to use the Vehicle Interface Module (VIM)

Write a comment