2002-2003 Yamaha YZF1000 R1 STARTING INSTALLATION

0

Filed Under (Yamaha) by admin on 13-01-2012

download
Remove the main seat and the passenger seat / solo cover. 2 Lift the front of the fuel tank up. 3 Locate the connectors shown in Fig. A. These connectors are located behind the throttle bodies on the left hand side of the bike. 4 Unplug the two connectors shown in Fig. A. Fig.A PLEASE READ ALL THE DIRECTIONS BEFORE STARTING INSTALLATION Unplug these connectors I405-211 6 3 Fig.B 5 Plug the fuel connectors from the PCIII (clear connectors) in-line of the stock wiring harness (Fig. B). Stock connectors PCIII connectors 6 Plug the TPS connectors from the PCIII (white connectors) in-line of the stock wiring harness (Fig. C). Fig.C Stock connectors PCIII connectors I405-211 Trouble Shooting If you feel that you are having any problems at all with the Power Commander III, disconnect it from your motorcycle. This will allow the motorcycle to run directly off of the stock ECU. The lights don’t come on when I turn the ignition switch on. Check to make sure connectors are seated and the kill switch is in the “run” position

Write a comment