BMW F650GS / F800GS Slip-On Exhaust System with M-2 Exhaust Canister Installation Instructions


Filed Under (Yamaha) by admin on 09-11-2010

1. Make sure the bike is completely cool before starting the installation. Make sure the bike is secure on a centerstand or ideally a service lift. 2. Remove muffler joint springs, set aside to re-use later. 3. Remove muffler mounting bolt and decorative washer, set aside to re-use washer later. 4. Attach TBR slip tube to TBR muffler using the 2 piece X-Rings and 6x14mm socket head cap screws with lock washer that are provided. Leave loose enough to make some adjustments on the motorcycle. 5. Attach muffler assembly to motorcycle using the OEM springs and supllied muffler clamp. Use the supplied 8x20mm socket head cap screw and OEM washer to secure muffler clamp. *a small amount of high temp silicone on slip joint may be used. 6. Align muffler and tighten the 4 X-Ring bolts. 7. Double check your work to ensure everything is tight and properly installed. 8. Before you run the bike, clean off all fingerprints and dirt, as any oily residue will etch the metal and become somewhat permanent when the system gets hot. Run the bike and enjoy. It is normal for some white smoke to appear the first time you start the bike. This is packing/ manufacturing oil from inside the pipe burning off. Check for gaps or leaks. If you find a leak, a little high temperature silicon sealant should fix it. After 50 to 100 miles, recheck all fasteners for tightness. 2008-09 BMW F650GS / F800GS V.A.L.E.™ Slip-On Exhaust System with M-2 Exhaust Canister Part # 005-2630406V / 005-2630407V / 005-2630408V Qty. Description Part Number 1 M-2 Muffler Canister Varies 1 Slip-On Tube Assembly 005-26304S 1 Muffler Clamp Varies 1 HARDWARE KIT 005-263-3 2 X-Ring (half) 005-7-2-3 4 6x14mm Socket Head Cap Screw 005-SH614 4 6mm Split Washer 005-WL6 1 8×20 Sockey Head Cap Screw

Write a comment