Filed Under (Yamaha) by admin on 18-01-2012
download
remove seat and gas tank. Make sure fuel petcock is in “off” position. 2. Remove throttle cable paying close attention to routing, as the new cable (s) will need too be routed the same. 3. Remove stock carburetor and stock throttle housing. Stuff a clean, dry rag into manifold to keep debris out of motor. 4. Remove stock air box. 5. Remove choke cable from handlebars. 6. Remove carb vent line from bike. Carburetor installation 1. Carefully trim the rubber alignment tab off of the face of the manifold with a razor blade or side cutters. 2. Remove the hex pipe plug from the carb cap using a 11mm or 7/16 wrench. Do not discard plug, as it will be needed later. Install the metering adjustment tool included in the hardware kit. Do not over-tighten as damage may occur to cap. 3. Attach fuel line to carburetor and secure with clamp. 4. Install remote idle cable into tab on top of carburetor. See main manual for this step. NOTE: Nut must be removed from cable before installation 5. Place carburetor into manifold
Incoming search terms:
- electrical schematics yamaha raptor 350 2005
- carburetor adjustments on CRF 50 F 2004
- 1968 Yamaha jog JVA2HE00-1-HA701744 Carburetor
- raptor 80 fuel leak from carb
- Raptor 660 carb spacer installation
- how to remove the carburator from yamaha AG 200
- how to install throttle cable on yamaha raptor
- 13 raptor 90 bogging
- 2004 yamaha raptor 350 rear fender for sale
- 2000 honda rancher es carb kit for sale