Yamaha TDM 900 Disconnecting the battery ground REMOVAL AND INSTALLATION


Filed Under (Yamaha) by admin on 29-01-2012

Remove the seat. • Disconnect the battery ground (negative terminal). Remove the fairing side panels. • Remove the four marked hex screws with plastic washers. Note the positions the screws come from as they are not all the same. • Note that the bottom, rear hex bolt has a retaining plastic washer INSIDE the fairing. The long bolt goes under the ‘twin’ label. • Remove the hex screw indicated on the inside of the fairing panel. • Remove the grey Phillip’s head screw as indicated on the inside panel. • Remove the plastic locking clip on the underside of the fairing behind the radiator.

Incoming search terms:

Write a comment

Incoming search terms: