YAMAHA XVS 1300 A INSTALLATION AND OWNER'S MANUAL

0

Filed Under (Yamaha) by admin on 13-01-2012

download
Place motorcycle on flat and level ground with side stand securely in place. Before installing fasteners we recommend you apply a small amount of Loctite ®medium strength #243 thread retaining compound (or similar brand) to the threads of the button head screws (a) referenced on page 3 and to the M8 x 50 fasteners supplied in Bag 914. (Thread Lock) INSTALLATION OF EYEBROW 1. Start on right side of the motorcycle and remove the 2 bolts from the fender and trim rail. Remove rear trim rail. Store bolts and trim rail, they will not be re-used. (5mm Hex Wrench) SPOOL ASSEMBLY, FRONT AND REAR 2. Assemble front and rear spool assemblies into the right eyebrow (4) and fender. Do not fully tighten. This will allow some movement which aids in the side plate installation. (5mm Hex Wrench) Figure 1. After final assembly fender mount screws will torque to: 22 Nm (17 ft/lb) 3. Repeat steps 1-2 for the left side fender assembly

Write a comment